Pioneer XR-P740M 사용 설명서 - 페이지 26

{카테고리_이름} Pioneer XR-P740M에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer XR-P740M 28 페이지. Stereo multi-play cd cassette deck receiver / stereo cd cassette deck receiver/ speaker system

TROUBLESHOOTING
Symptom
?
preceaaciGOT
|
No sound from speakers. | @
s
Cassette
door
does
not!
@
open.
Cannot record.
®
Sound is muffled.
Previously recorded
sounds remain.
yoap
ade
ajjesseg
Sound is muffled.
Treble
tones too strong.
| Playback dees not start.
e
°
oo
3
Ey
<
o
=
oun]
Sound is distorted.
®
There is no stereo sound.
| @
Cause
AC cord is unplugged.
All cords are not connected firmly.
Function is not set to the desired
listening source on the receiver.
The power
cord was
unplugged
while tape was running.
Erasure prevention tabs are broken
off.
Dirty heads.
Tape recorded with DOLBY NR but
played without.
Disc is loaded upside down.
Dirt, blur, etc. on the disc.
Disc has bad scratch or warp.
Antenna not connected.
Antenna in poor position.
interference
from
nearby
fluorescentlight, hair dryer, or other
electrical appliance.
The MONO indicator in the display
window on the receiver lights up.
Timer does not work.
®
Current time is not set.
Remote
control does not;
@
work,
8
S190
In the one-touch
karaoke|
6
mode, noise is heard when
using microphone.
Batteries are run down,
A fluorescent light is shining on the
remote sensor window.
Interference
from
nearby
fluorescent light, hair dryer, or other
electrical appliance.
Abnormal functioning of this unit may be caused by lightning,
static electricity, ar other external interference. To restore
normal operation, turn the power off and then on again, or
unplug the AC power cord and then plug it in again.
26
<ARB7006>
En
Remedy
Plug power cord into wall socket correctly.
Connect cords correctly referring to
CONNECTIONS on page 6.
@
Select correct function.
Piug the power cord.
e
Use cassette that can be recorded on, or
apply adhesive tape over tab holes.
@
Clean heads.
Turn on DOLBY NR system for tapes
recorded with DOLBY NR.
Load a disc correctly with the label side
{printed side) UP.
(With the magazine
type, load a disc with the label side
DOWN,
Clean the disc.
Replace the disc.
Connect antenna correctly.
Change antenna pasition.
Stop using device causing interference.
Press MONO so thatthe MONO indicator
goes out.
@
Set current time.
®
Replace with new batteries.
@
Movethe unit away from the fluorescent
light.
e
Stop using device causing interference.