Pioneer XR-P740M Instrukcja obsługi - Strona 26

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odbiornik samochodowy Pioneer XR-P740M. Pioneer XR-P740M 28 stron. Stereo multi-play cd cassette deck receiver / stereo cd cassette deck receiver/ speaker system

Drukuj stronę

TROUBLESHOOTING

Symptom

preceaaciGOT

No sound from speakers. | @

Cassette

door

does

not!

open.

Cannot record.

Sound is muffled.

Previously recorded

sounds remain.

yoap

ade

ajjesseg

Sound is muffled.

Treble

tones too strong.

| Playback dees not start.

oun]

Sound is distorted.

There is no stereo sound.

| @

Cause

AC cord is unplugged.

All cords are not connected firmly.

Function is not set to the desired

listening source on the receiver.

The power

cord was

unplugged

while tape was running.

Erasure prevention tabs are broken

off.

Dirty heads.

Tape recorded with DOLBY NR but

played without.

Disc is loaded upside down.

Dirt, blur, etc. on the disc.

Disc has bad scratch or warp.

Antenna not connected.

Antenna in poor position.

interference

from

nearby

fluorescentlight, hair dryer, or other

electrical appliance.

The MONO indicator in the display

window on the receiver lights up.

Timer does not work.

Current time is not set.

Remote

control does not;

work,

S190

In the one-touch

karaoke|

mode, noise is heard when

using microphone.

Batteries are run down,

A fluorescent light is shining on the

remote sensor window.

Interference

from

nearby

fluorescent light, hair dryer, or other

electrical appliance.

Abnormal functioning of this unit may be caused by lightning,

static electricity, ar other external interference. To restore

normal operation, turn the power off and then on again, or

unplug the AC power cord and then plug it in again.

Remedy

Plug power cord into wall socket correctly.

Connect cords correctly referring to

CONNECTIONS on page 6.

Select correct function.

Piug the power cord.

Use cassette that can be recorded on, or

apply adhesive tape over tab holes.

Clean heads.

Turn on DOLBY NR system for tapes

recorded with DOLBY NR.

Load a disc correctly with the label side

{printed side) UP.

(With the magazine

type, load a disc with the label side

DOWN,

Clean the disc.

Replace the disc.

Connect antenna correctly.

Change antenna pasition.

Stop using device causing interference.

Press MONO so thatthe MONO indicator

goes out.

Set current time.

Replace with new batteries.

Movethe unit away from the fluorescent

light.

Stop using device causing interference.