Pioneer AVH-P4200DVD 설치 매뉴얼 - 페이지 2

{카테고리_이름} Pioneer AVH-P4200DVD에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer AVH-P4200DVD 8 페이지. Dvd rds av receiver
Pioneer AVH-P4200DVD에 대해서도 마찬가지입니다: 설치 매뉴얼 (40 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

Connecting the units

Connecting the power cord

AUX jack (3.5 ø) (AVH-P4200DVD)

Use a mini plug cable to connect with auxiliary device.

Navigation unit can

Microphone input (AVH-P3200BT)

be connected

(AVIC-F220 (sold

26 pin cable (Supplied with Navigation unit)

separately)).

Insert the 26 pin cable in the

Please contact your dealer to

direction indicated in the figure.

inquire about the

RGB input

connectable navigation unit.

Note:

Depending on the kind of vehicle,

the function of 2* and 4* may be

This product

different. In this case, be sure to

Fuse (10 A)

connect 1* to 4* and 3* to 2*.

Antenna input

Connect leads of the same

color to each other.

Yellow (2*)

Yellow (1*)

Back-up

Connect to the constant 12 V

(or accessory)

supply terminal.

Fuse resistor

Red (4*)

Red (3*)

Accessory

Connect to terminal controlled by

(or back-up)

ignition switch (12 V DC).

Orange/white

Fuse resistor

Connect to lighting switch terminal.

Black (chassis ground)

Connect to a clean, paint-free metal location.

ISO connector

Speaker leads

Front left 

Note:

White:

White/black: Front left 

In some vehicles, the ISO connector may be divided into

Front right 

two. In this case, be sure to connect to both connectors.

Gray:

Front right 

Gray/black:

When you connect the separately sold

Rear left  or subwoofer 

Green:

multi-channel processor (DEQ-P6600) to this

Green/black: Rear left  or subwoofer 

unit, do not connect anything to the speaker

Rear right  or subwoofer 

Violet:

leads and system remote control (blue/white).

Rear right  or subwoofer 

Violet/black:

Connecting the units

4 m

Microphone

(AVH-P3200BT only)

Wired remote

Fuse resistor

Violet/white

input

Of the two lead wires connected to the back lamp, connect the one

Hard-wired

in which the voltage changes when the gear shift is in the

remote control

REVERSE (R) position. This connection enables the unit to

adaptor can be

sense whether the car is moving forwards or backwards.

connected (sold

separately).

(AVH-

P4200DVD

Yellow/black

only)

If you use an equipment with Mute function, wire this lead to

the Audio Mute lead on that equipment. If not, keep the Audio

Mute lead free of any connections.

Connection method

1. Clamp the lead.

Note:

· The position of the parking brake switch depends on the vehicle model. For details,

consult the vehicle Owner's Manual or dealer.

Light green

Used to detect the ON/OFF status of the parking brake. This lead

must be connected to the power supply side of the parking brake

switch.

Blue/white

Connect to system control terminal of the power

Power supply side

amp (max. 300 mA 12 V DC).

Ground side

Blue/white (6*)

Blue/white (5*)

Connect to auto-antenna relay control terminal

(max. 300 mA 12 V DC).

The pin position of the ISO

connector will differ depending on

Notes:

the type of vehicle. Connect 5* and

· Change the initial setting of this unit (refer to the Operation Manual). The

6* when Pin 5 is an antenna control

subwoofer output of this unit is monaural.

type. In another type of vehicle,

· When using a subwoofer of 70 W (2 Ω) , be sure to connect with Violet and

never connect 5* and 6*.

Violet/black leads of this unit. Do not connect anything to Green and

Green/black leads.

Connecting the units

Connecting the system (AVH-P4200DVD only)

IP-BUS input

This product

Wired remote input

Hard-wired remote control

adaptor can be connected

(sold separately).

When connecting with supplied USB cable (AVH-P4200DVD

only)

2. Clamp firmly with

needle-nosed pliers.

IP-BUS input

Wired remote input

Hard-wired remote control

adaptor can be connected

(sold separately).

Parking brake

switch

This product

USB cable

(supplied with this unit)

1.5 m

Connect to sparately sold

USB device.

Connecting the units

When connecting with optional CD-IU200V cable (AVH-

P4200DVD only)

Microphone

for hands-free phoning

(supplied with Bluetooth adapter)

Bluetooth adapter

IP-BUS input

(e.g. CD-BTB200)

AUX input (AUX)

(sold separately)

Black

1.5 m

This product

IP-BUS cable

(Supplied with Bluetooth adapter)

Microphone

for hands-free phoning

(supplied with Bluetooth adapter)

Bluetooth adapter

(e.g. CD-BTB200)

(sold separately)

Black

1.5 m

IP-BUS cable

(Supplied with Bluetooth adapter)

Microphone

for hands-free phoning

(supplied with Bluetooth adapter)

Wired remote input

Bluetooth adapter

(e.g. CD-BTB200)

Hard-wired remote control adaptor

can be connected (sold separately).

(sold separately)

iPod with video capabilities

(sold separately)

USB input

Black

1.5 m

Dock connector

USB cable

IP-BUS cable

1.5 m

(Supplied with Bluetooth adapter)

Interface cable

(CD-IU200V) (sold separately)