Pioneer AVH-P4200DVD Instrukcja instalacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Odbiornik Pioneer AVH-P4200DVD. Pioneer AVH-P4200DVD 8 stron. Dvd rds av receiver
Również dla Pioneer AVH-P4200DVD: Instrukcja instalacji (40 strony), Skrócona instrukcja obsługi (2 strony)
Drukuj stronę
Connecting the units
Connecting the power cord
AUX jack (3.5 ø) (AVH-P4200DVD)
Use a mini plug cable to connect with auxiliary device.
Navigation unit can
Microphone input (AVH-P3200BT)
be connected
(AVIC-F220 (sold
26 pin cable (Supplied with Navigation unit)
separately)).
Insert the 26 pin cable in the
Please contact your dealer to
direction indicated in the figure.
inquire about the
RGB input
connectable navigation unit.
Note:
Depending on the kind of vehicle,
the function of 2* and 4* may be
This product
different. In this case, be sure to
Fuse (10 A)
connect 1* to 4* and 3* to 2*.
Antenna input
2*
1*
Connect leads of the same
4*
3*
color to each other.
Yellow (2*)
Yellow (1*)
Back-up
Connect to the constant 12 V
(or accessory)
supply terminal.
Fuse resistor
Red (4*)
Red (3*)
Accessory
Connect to terminal controlled by
(or back-up)
ignition switch (12 V DC).
Orange/white
Fuse resistor
Connect to lighting switch terminal.
Black (chassis ground)
Connect to a clean, paint-free metal location.
ISO connector
Speaker leads
Front left
Note:
White:
White/black: Front left
In some vehicles, the ISO connector may be divided into
Front right
two. In this case, be sure to connect to both connectors.
Gray:
Front right
Gray/black:
When you connect the separately sold
Rear left or subwoofer
Green:
multi-channel processor (DEQ-P6600) to this
Green/black: Rear left or subwoofer
unit, do not connect anything to the speaker
Rear right or subwoofer
Violet:
leads and system remote control (blue/white).
Rear right or subwoofer
Violet/black:
Connecting the units
4 m
Microphone
(AVH-P3200BT only)
Wired remote
Fuse resistor
Violet/white
input
Of the two lead wires connected to the back lamp, connect the one
Hard-wired
in which the voltage changes when the gear shift is in the
remote control
REVERSE (R) position. This connection enables the unit to
adaptor can be
sense whether the car is moving forwards or backwards.
connected (sold
separately).
(AVH-
P4200DVD
Yellow/black
only)
If you use an equipment with Mute function, wire this lead to
the Audio Mute lead on that equipment. If not, keep the Audio
Mute lead free of any connections.
Connection method
1. Clamp the lead.
Note:
· The position of the parking brake switch depends on the vehicle model. For details,
consult the vehicle Owner's Manual or dealer.
Light green
Used to detect the ON/OFF status of the parking brake. This lead
must be connected to the power supply side of the parking brake
switch.
Blue/white
Connect to system control terminal of the power
Power supply side
amp (max. 300 mA 12 V DC).
Ground side
Blue/white (6*)
Blue/white (5*)
Connect to auto-antenna relay control terminal
(max. 300 mA 12 V DC).
The pin position of the ISO
connector will differ depending on
Notes:
the type of vehicle. Connect 5* and
· Change the initial setting of this unit (refer to the Operation Manual). The
6* when Pin 5 is an antenna control
subwoofer output of this unit is monaural.
type. In another type of vehicle,
· When using a subwoofer of 70 W (2 Ω) , be sure to connect with Violet and
never connect 5* and 6*.
Violet/black leads of this unit. Do not connect anything to Green and
Green/black leads.
Connecting the units
Connecting the system (AVH-P4200DVD only)
IP-BUS input
This product
Wired remote input
Hard-wired remote control
adaptor can be connected
(sold separately).
When connecting with supplied USB cable (AVH-P4200DVD
only)
2. Clamp firmly with
needle-nosed pliers.
IP-BUS input
Wired remote input
Hard-wired remote control
adaptor can be connected
(sold separately).
Parking brake
switch
This product
USB cable
(supplied with this unit)
1.5 m
Connect to sparately sold
USB device.
Connecting the units
When connecting with optional CD-IU200V cable (AVH-
P4200DVD only)
Microphone
for hands-free phoning
(supplied with Bluetooth adapter)
Bluetooth adapter
IP-BUS input
(e.g. CD-BTB200)
AUX input (AUX)
(sold separately)
Black
1.5 m
This product
IP-BUS cable
(Supplied with Bluetooth adapter)
Microphone
for hands-free phoning
(supplied with Bluetooth adapter)
Bluetooth adapter
(e.g. CD-BTB200)
(sold separately)
Black
1.5 m
IP-BUS cable
(Supplied with Bluetooth adapter)
Microphone
for hands-free phoning
(supplied with Bluetooth adapter)
Wired remote input
Bluetooth adapter
(e.g. CD-BTB200)
Hard-wired remote control adaptor
can be connected (sold separately).
(sold separately)
iPod with video capabilities
(sold separately)
USB input
Black
1.5 m
Dock connector
USB cable
IP-BUS cable
1.5 m
(Supplied with Bluetooth adapter)
Interface cable
(CD-IU200V) (sold separately)