Pioneer Elite PRO-R06U 교육 매뉴얼 - 페이지 39

{카테고리_이름} Pioneer Elite PRO-R06U에 대한 교육 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer Elite PRO-R06U 47 페이지. Pioneer 6th generation plasma media receivers

6G MR (Tips for removing the Main PCB）

Use the chart below to remove each PCB.

Front Panel

LED board

Front input board

PC card board

Note:

Remove the 2 parts, shown by red circles, before removing Front Panel Assy.

( The reason is that FCC will be pulled when removing Front Panel Assy. )

Remove FCC

In case of placing Power Supply, Digital Tuner and AV PCB, make sure to attach the screw on the Connector Panel side first.

( The reason is to prevent the stress to PCB and solder. )

Please pay attention the styling and binding of cord around Power Supply.

After replacing the parts, stabilize the FAN (60X25L) with tape as shown before removing in order to prevent a loose FAN while shipping.

Note: Please pay attention for not breaking screw. The screw for HDMI and I-Link are weak and tend to be broken.

Bonnet

Fan motor

DTB

Fan motor

Power Supply

Main board

Remove Flat Clamp

Make a note of the wire locations.

Make sure to clamp the cords under the

Cable Clamp.

Fan connectors need to be connected as pictured.

For FAN (60 X25L)

For FAN (40 X 10.5L)

Use asetate tape, approx 10mm wide.