Pioneer Elite SC-27 사용 설명서 - 페이지 8
{카테고리_이름} Pioneer Elite SC-27에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer Elite SC-27 36 페이지. Audio/video multi-channel receiver, advanced mcacc pc display application software
Pioneer Elite SC-27에 대해서도 마찬가지입니다: 사양 (2 페이지), 펌웨어 업데이트 지침 (5 페이지), 펌웨어 업데이트 지침 (4 페이지)
페이지 인쇄
Operations on the Receiver and Cable Connections (Continued)
2
Perform the "Full Auto MCACC" operation on the receiver. (See page 46 (SC-27,
SC-25)/42 (SC-9540) of the receiver's Operating Instructions.)
The measurements here are not required if the "Full Auto MCACC" operation has already been
performed before connecting the RS-232C cable. Proceed to
3
Select "Output PC" from "MCACC Data Check". (See page 118 (SC-27, SC-25)/104
(SC-9540) of the receiver's Operating Instructions.)
The message "Start the MCACC application on your PC" appears on the monitor screen and the receiver
enters the transmission standby mode. It is ready to send data to your PC.
a. Speaker Setting
b. Channel Level
c. Speaker Distance
d. Standing Wave
e. Acoustic Cal EQ
f. Group Delay
g. Output PC
Exit
This completes the preparations for sending the measurement data to your PC.
(To send the data, proceed to the next section Application Operations.)
Note
• The graphs for both before calibration ("Before") and after calibration ("After") can be displayed on the
screen displaying the reverberation characteristics graphs after Full Auto MCACC measurements
("Reverb"), but note that the graph displayed for the characteristics after calibration is a prediction of
the reverberation characteristics after Full Auto MCACC with the EQ Type : SYMMETRY.
For details, see
About the display of the reverb characteristics graphs before and after calibration
(page
23).
If you want to check the graph of the actually measured reverberation characteristics after MCACC
calibration (not the prediction), measure the reverb characteristics again after calibration.
For details, see
Displaying the reverb characteristics after EQ calibration (actually measured values)
(page
24).
2.MCACC Data Check
A/V RECEIVER
Return
step
3.
2g.Output PC
A/V RECEIVER
Start the MCACC application on your PC.
Exit
8
Cancel