Pioneer A-09 서비스 매뉴얼 - 페이지 35

{카테고리_이름} Pioneer A-09에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer A-09 37 페이지.

페이지 인쇄

A-09

7. PANEL FACILITIES

IONEER

srucoaecen

Class|A Power Stage

FRONT PANEL

@) POWER switch

Press to turn power to the unit ON and OFF.

@ VOLUME CONTROL

This control is used to adjust the sound volume.

NOTE:

Since this control is an attenuator-type volume control, a

clicking sound can be heard when adjusting the volume, in

accordance with the signal level. This clicking sound is normal

and not a malfunction.

@ VOLUME CONTROL indicator

This indicator flashes for about eight seconds whenever the

power is first turned on.

No sound

is produced while the

indicator is flashing.

@ INPUT SELECTOR

Use to select the playback source.

LINE:

For playback with a component connected to LINE

jacks.

TAPE 2:

For playback with a cassette deck connected to TAPE

2 jacks.

TAPE 1/DAT:

For playback with a cassette deck or digital audio

cassette deck connected to TAPE 1/DAT jacks.

cD:

For compact disc playback with a CD player.

PHONO:

For record playback with a turntable.

TUNER:

For AM or FM broadcast reception with a tuner.

BALANCE:

For playback with a component connected to the

BALANCE IN jacks.

@ REC SELECTOR (recording selector)

Use this contro! to switch between recording modes,

including TAPE 2 > 1, TAPE 1 > 2, OFF, and SOURCE.

TAPE 2 > 1: To record sounds from the TAPE 2 component

to the component connected to the TAPE 1/ DAT

jacks.

TAPE 1> 2:

To record sounds from the TAPE 1/DAT compo-

nent to the component connected to the TAPE

2 jacks.

OFF:

Set here when not recording any source.

SOURCE:

To record sounds from the source selected with

the INPUT SELECTOR.

In this case, the selected

source

sounds

are output to both the TAPE

V/DAT and TAPE 2 recording (REC) jacks.

NOTE:

Sound is not output to the TAPE 1/DAT and TAPE 2 recording

(REC) jacks in the following cases:

When the INPUT SELECTOR is set to TAPE 1/DAT, sound

is not output to the TAPE 1/DAT jacks.

When the INPUT SELECTOR is set to TAPE 2, sound is not

output to the TAPE 2 jacks.