Pioneer A-107 사용 설명서 - 페이지 11

{카테고리_이름} Pioneer A-107에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer A-107 12 페이지. Stereo
Pioneer A-107에 대해서도 마찬가지입니다: 서비스 매뉴얼 (8 페이지), 사용 설명서 (13 페이지)

페이지 인쇄

TROUBLESHOOTING

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component,

check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical

appliances being used.

If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center

or your dealer to carry out repair work.

Symptom

No power supplied to unit.

No sound.

No sound from one speaker.

Cannot record tapes.

Cannot perform tape copy-

ing.

Abnormal functioning of this unit may be cased by, static electricity, or other external interference. To restore normal operation, turn

the power off and then on again, or unplug the AC power cord and then plug it in again.

Cause

÷ Power plug is disconnected from outlet.

÷ The amplifier's power plug has been plugged

into another component's power outlet (e.g.

timer, etc.) but power to that unit is discon-

nected.

÷ The AC INLET plug is disconnected.

÷ Connecting cords are disconnected from ter-

minals, or connected incorrectly.

÷ Terminals, or connecting cords pin plugs are

dirty.

÷ The TAPE 2 MONITOR button is set to ON

(except when using an adaptor component).

÷ Operation of other components is incorrect.

÷ The position of the INPUT SELECTOR does

not match the component to be played back.

÷ SPEAKERS button is set to OFF.

÷ Connecting cords or speaker cords are discon-

nected on that side.

÷ BALANCE control is set to one side.

÷ Connections are incorrect.

÷ Operation of cassette deck is incorrect.

÷ The TAPE 2 MONITOR button is set to ON.

÷ The position of the INPUT SELECTOR knob

and TAPE 2 MONITOR button are incorrect

(when using 2 cassette decks).

÷ Operation of cassette decks is incorrect.

Remedy

÷ Insert plug securely into outlet.

÷ Turn on power to other component.

÷ Insert the AC INLET plug securely till the

bottom of the jack.

÷ Connect securely.

÷ Clean terminals and plugs.

÷ Set the button to OFF.

÷ Consult the operating instructions for

the other components.

÷ Set the button correctly (CD, TUNER,

PHONO, LINE, TAPE 1/MD).

÷ Set the button to ON.

÷ Connect securely.

÷ Set BALANCE control to center posi-

tion.

÷ Reconnect properly.

÷ Consult the operating instructions for

the cassette deck.

÷ Set the TAPE 2 MONITOR button to

OFF.

÷ Set buttons correctly. (See section

COPYING TAPES.)

÷ Consult the operating instructions for

the cassette decks.