Pioneer A-40AE 사용 설명서 - 페이지 15

{카테고리_이름} Pioneer A-40AE에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer A-40AE 24 페이지.

Speaker impedance settings

8Ω

Depending on the speakers you connect and how you

connect them, you may need to change the speaker

impedance setting on this unit. Refer to the page describing

speaker connection (p8, 9, 10) and do the following

procedures if the change is required.

1. Press and hold DIRECT until some indicators, such as

the input source indicators "CD/SACD" and "LINE 1", start

blinking on the unit.

0 The unit has switched to the setting mode when the

indicators blink and the current setting is displayed.

2. Take your finger off DIRECT for a moment.

3. Press and hold DIRECT again to change the setting. The

following content switches alternately by pressing and

holding the button.

- 4 ≠: "CD/SACD" and "LINE 1" indicators are blinking

- 8 ≠ (default value): "CD/SACD", "LINE 1", "LINE 2",

and "LINE 3" indicators are blinking

0 The setting mode ends after 5 seconds elapse with no

operations performed.

4Ω

Preparations