Pioneer C-90S 사용 설명서 - 페이지 2

{카테고리_이름} Pioneer C-90S에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer C-90S 32 페이지. Stereo control amplifier

Pioneer C-90S 사용 설명서
IMPORTANT
1
The lightning flash with arrowhead, within an equi-
lateral tiangie, is intended to alert the user of the
presence of uninsulated "dangerous voltage" within
the product's enclosure that may be of sufficient
magnitude to constitute a risk of electric shock to
persons
IMPORTANT 2
if the apparatus is fitted with AC mains power out-
lei(e). see REAR PANEL FACILITIES for convenient
connection of additional Hi-Fi component(s). Make
all connections to the AC outlet(s) and the signal
terminals first, Connect the plug to the wall socket
last, make sure that the power switch is off
CAUTION
RISK OF ELECTRIC SHOCK.
DO NOT OPEN
CAUTION:
TO PREVENT THE RISK OF ELECTRIC SHOCK,
DO
NOT
REMOVE
COVER
(OR
BACK}.
NO
USER-SERVICEABLE
PARTS
INSIDE.
REFER
SERVICING
TO
QUALIFIED
SERVICE
PERSONNEL.
FOR USE IN THE UNITED
KINGDOM
The wires in this marns lead are coloured in accor-
dance with the following code:
Blue
Neutral
Brown:
Live
READ
INSTRUCTIONS — Alt
the
safety
and
operating instructions should be read before the
appliance is operated
RETAIN INSTRUCTIONS
-~ The operating instruc:
tions should be retained for future reference.
HEED WARNING ~- All warnings on the apphance
and in the operating
instructions
should
be
adhered to.
FOLLOW INSTRUCTIONS — All operating and use
instructions should be followed.
WATER AND MOISTURE — The appliance should
not be used near water
for example,
near a
bathtub, washbowt, kitchen sink. laundry tub, in
wet basement, of near a swimming pool, etc
LOCATION -— The appliance should be installed in a
stable location
WALL OR CEILING MOUNTING — The appliance
should mot be mounted to a wall or ceiling
VENTILATION -- The appliance should be situated
80 that its location or position does not interfere
with its proper ventilation. For example, the ap-
pliance shauid not be situated on a bed, sofa, rug,
or similar surface that may block the ventilation
openings: ar, placed in a built-in installation, such
as 3 bookcase or cabinet that may impede the
flow of air through the ventilation openings
HEAT — The appliance should be situated away from
heat sources such as radiators, heat registers,
stoves, ot other appliances (including amplifiers)
that produce heat
POWER
SOURCES —The appliance should be
connected to a power supply only of the type
described
in the operating
instructions
of as
marked on the appliance.
POWER-CORD
PROTECTION -- Power-supply
cords should be routed so that they are not likely
to be walked on or pinched by items placed upon
'ot against them, paying particular attention to
cords at plugs, convenience receptacies. and the
point where they exit from the appliance
POLARIZATION — ff your
purchased
product
is
provided with a polarized power plug. please read
the following
instructions.
This product
is
equipped with a polarized alternating current line
plug {a plug having one blade wider than the
other). This plug will fit unto the power outlet only
SAFETY INSTRUCTIONS
POWER LINES — An outdoor antenna should be
located away from power fines
NONUSE
PERIODS —The power cord of the
appliance should be unplugged from the outlet
when left unused for a long period of time
OBJECT AND LIQUID ENTRY — Care should be
taken so that objects do not fail and liquids are
not spilled into the enclosure through openings.
DAMAGE REQUIRING SERVICE — The anpliance
should be serviced by a Pioneer authorized ser-
vice center or qualified service personne! when
©
The power-supply cord or the plug has been
damaged: or
©
Objects have fallen, or liquid has been spilled into
the appliance; or
®
The apptiance has been exposed to rain: ot
©
The apptiance does not appear to operate nor-
mally or exhibits a marked change in perfor.
mance; or
©
The appliance has been dropped: or the enclosure
damaged
SERVICING —The user should not attempt to
service the appliance beyond that described in the
operating instructions. For alt other servicing,
contact the nearest Pioneer authorized service
center.
POWER LINES.
SERVICE
"
ENTRANCE
CONDUCTORS,
GROUND WIRE ab
The exciamation point within an equilateral triangle is
intended to alert the user of the presence of important
operating and maintenance (servicing) instructions in
the litereture accompanying the appliance.
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured
marking identifying the terminals in your plug proceed
as follows:
The wire which is coloured blue must be connected to
the terminal which is marked with the letter N or
coloured bleck
The wire which is coloured brown must be connected
to the terminal which is marked with the letter & or
coloured red.
Equipment sold in the U.K. is not supplied with
2 power piug
OUTDOOR ANTENNA GROUNDING — if an out~
side antenna is connected to the antenna termi-
nat, be sure the antenna system is grounded so as
10 provide some protection against voltage surges.
and built up static charges.
in the U.S.A. section 810 of the National Elec-
trical Code. ANSI/NFPA No. 70-1984, provides
information with respect to proper grounding of
the mast and supporting structure, grounding of
the lead-in wire to an antenna discharge unit, size
of grounding conductors, tocation of antenns-
discharge unit, connection to grounding elec-
todes, and requirements for the grounding elec
trode. See Fig A
a}
Use No 10 AWG (5.3 mm?) cop-
per, No 8 AWG (8.4 mm*) alu-
minum. No. 17 AWG (1.0 mm?)
copperciad steel, bronze wire.
or
larget as ground wire
6)
Secure
antenna
fead-in
and
ground
wires
to
house
with
stand-off insulators spaced
tram.
4 feet
(1.22
meters)
to 6 feet
(1.83 meters} apart
c} Mount antenna discharge unit as
closely as possible to where lead-
wn enters house
STAND-OFE
d}
Use jumper wire not smatier than
INSULATORS
Noe AWG (13.3 mm*) copper,
or the equivalent, when a sepa-
rate antenna-grounding electrode
is used
See NEC Section 810-21 {j)
ANTENNA
LEAD IN WIRE
TO EXTERNAL ANTENNA
TERMINALS OF PRODUCT
ANTENNA
one way. This is a safety feature. Hl you are unable
ce ewraance
gAouNe
OCRANGE UNIT ¢
1o insert the plug fully inte the outlet, ty reversing
Eguipaaent
eaOUNE.
the plug. Hf the plug should still fait 10 fit, contact
WIRE a,b
your electrician to teptace your obsolete outtet
Do not defeat the safety purpose of the polarized
;
'cRGUND
plug
POWER SERVICE
CLEANING —- The appliance should be cleaned only
GROUNDING ELECTRODE SYSTER
with 2 polishing cloth or a soft dry cloth. Never
(©.9 terior metal water pine}
clean with furniture wax, benzine, ingecticides or
ots
H
other volatile hquids since they may conede the
it
amma
ey
cabinet
FIG.A
#8
LOCAL CODES SEE
'BNET SECTION 830.23 (1)
PS CLAMPS
7 OPTIONAL ANTENNA
GROUNDING ELECTRODE
DRIVEN & FEET (2.44 m)
2
<ARBI140>