Pioneer GM-3400T 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Pioneer GM-3400T에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer GM-3400T 48 페이지. Bridgeable two-channel power amplifier
Pioneer GM-3400T에 대해서도 마찬가지입니다: 소유자 매뉴얼 (41 페이지), 소유자 매뉴얼 (17 페이지)

페이지 인쇄

Section

Connecting the units

Connection diagram

1 Special red battery wire

RD-223 (sold separately)

After completing all other amplifier connec-

tions, finally connect the battery wire terminal

of the amplifier to the positive (+) battery

terminal.

2 Ground wire (Black)

RD-223 (sold separately)

Connect to metal body or chassis.

3 Car stereo with RCA output jacks (sold sepa-

rately)

4 External output

If only one input plug is used, do not connect

anything to RCA input jack B.

5 Connecting wire with RCA pin plugs (sold se-

parately)

6 Speaker input terminal

Please see the following section for speaker

connection instructions. Refer to Connections

when using the speaker input wire on page 8.

7 RCA input jack

8 System remote control wire (sold separately)

Connect male terminal of this wire to the sys-

tem remote control terminal of the car stereo

(SYSTEM REMOTE CONTROL). The female

terminal can be connected to the auto-anten-

na relay control terminal. If the car stereo

lacks a system remote control terminal, con-

nect the male terminal to the power terminal

via the ignition switch.

9 Speaker output terminals

Please see the following section for speaker

connection instructions. Refer to Connections

when using the speaker input wire on page 8.

a Fuse (30 A) × 2

b Fuse (30 A) × 2

c Grommet

d Rear side

e Front side

Before connecting the

amplifier

WARNING

! Secure the wiring with cable clamps or adhe-

sive tape. To protect the wiring, wrap sections

in contact with metal parts in adhesive tape.

! Never cut the insulation of the power supply

to feed power to other equipment. Current ca-

pacity of the wire is limited.

CAUTION

! Never shorten any wires, the protection circuit

may malfunction.

! Never ground speaker wire directly or band to-

gether multiple speakers' negative (*) lead

wires.