Pioneer GM-3400T 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Pioneer GM-3400T에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer GM-3400T 48 페이지. Bridgeable two-channel power amplifier
Pioneer GM-3400T에 대해서도 마찬가지입니다: 소유자 매뉴얼 (41 페이지), 소유자 매뉴얼 (17 페이지)

페이지 인쇄

Connecting the units

! If the system remote control wire of the ampli-

fier is connected to the power terminal via the

ignition switch (12 V DC), the amplifier will re-

main on with the ignition whether the car

stereo is on or off, which may exhaust battery

if the engine is at rest or idling.

! Install and route the separately sold battery

wire as far as possible from the speaker wires.

Install and route the separately sold battery

wire, ground wire, speaker wires and the am-

plifier as far away as possible from the anten-

na, antenna cable and tuner.

About bridged mode

Speaker impedance is max. 4 W, please carefully

check. Improper connection to the amplifier may

result in malfunction or personal injury due to

burns from overheating.

For bridged mode for a two-channel amplifier,

with a 4 W load, either wire two 8 W speakers in

parallel, Left + and Right * (Diagram A) or use a

single 4 W speaker. For other amplifiers, please

follow the speaker output connection diagram for

bridging shown on rear: two 8 W speakers in par-

allel for a 4 W load or a single 4 W speaker per

channel.

For any further enquiries, contact your local

authorized Pioneer dealer or customer service.

About suitable

specification of speaker

Ensure speakers conform to the following

standards, otherwise there is a risk of fire,

smoke or damage. Speaker impedance is 2 W

to 8 W for stereo connection, or 4 W to 8 W for

monaural and other bridge connection.

Subwoofer

Speaker channel

Two-channel output

One-channel output

Other than subwoofer

Speaker channel

Two-channel output

One-channel output

Connecting the speakers

The speaker output mode can be two-channel

(stereo) or one-channel (mono). Connect the

speaker leads to suit the mode according to

the figures shown below.

Power

Nominal input:

Min. 135 W

Nominal input:

Min. 420 W

Power

MAX input:

Min. 250 W

MAX input:

Min. 760 W

Section