Pioneer GM-A5702 소유자 매뉴얼 - 페이지 13

{카테고리_이름} Pioneer GM-A5702에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer GM-A5702 33 페이지. Bridgeable two-channel
Pioneer GM-A5702에 대해서도 마찬가지입니다: 소유자 매뉴얼 (19 페이지), 소유자 매뉴얼 (33 페이지), 소유자 매뉴얼 (16 페이지)

페이지 인쇄

Connecting the units

1 Terminal screws

2 Speaker wires

3 Speaker output terminals

Installation

Before installing the amplifier

WARNING

! To ensure proper installation, use the supplied

parts in the manner specified. If any parts

other than those supplied are used, they may

damage internal parts of the amplifier, or be-

come loose causing the amplifier to shut

down.

! Do not install in:

— Places where it could injure the driver or

passengers if the vehicle stops suddenly.

— Places where it may interfere with the dri-

ver, such as on the floor in front of the dri-

ver's seat.

! Install tapping screws in such a way that the

screw tip does not touch any wire. This is im-

portant to prevent wires from being cut by vi-

bration of the car, which can result in fire.

! Make sure that wires do not get caught in the

sliding mechanism of the seats or touch the

legs of a person in the vehicle as short-circuit

may result.

! When drilling to install the amplifier, always

confirm no parts are behind the panel and

protect all cables and important equipment

(e.g. fuel/brake lines, wiring) from damage.

CAUTION

! To ensure proper heat dissipation of the ampli-

fier, ensure the following during installation:

— Allow adequate space above the amplifier

for proper ventilation.

— Do not cover the amplifier with a floor mat

or carpet.

! Protection function may activate to protect the

amplifier against overheating due to installa-

tion in locations where sufficient heat cannot

be dissipated, continuous use under high-vo-

lume conditions, etc. In such cases, the am-

plifier reduces the power output or shuts

down until it has cooled to a certain desig-

nated temperature.

! Place all cables away from hot places, such

as near the heater outlet.