Pioneer GM-A5702 소유자 매뉴얼 - 페이지 13

{카테고리_이름} Pioneer GM-A5702에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer GM-A5702 16 페이지. Bridgeable two-channel
Pioneer GM-A5702에 대해서도 마찬가지입니다: 소유자 매뉴얼 (19 페이지), 소유자 매뉴얼 (33 페이지), 소유자 매뉴얼 (33 페이지)

Pioneer GM-A5702 소유자 매뉴얼
Connecting the units
Connecting the speaker
output terminals
1
Use wire cutters or a utility knife to
strip the end of the speaker wires to ex-
pose about 10 mm of wire and then twist
the wire.
2
Attach lugs to wire ends.
Use pliers, etc., to crimp lugs to wires.
1 Lug (sold separately)
2 Speaker wire
3
Connect the speaker wires to the
speaker output terminals.
Fix the speaker wires securely with the term-
inal screws.
1 Terminal screws
2 Speaker wires
3 Speaker output terminals

Installation

Before installing the amplifier

! To ensure proper installation, use the supplied
parts in the manner specified. If any parts
other than those supplied are used, they may
damage internal parts of the amplifier, or be-
come loose causing the amplifier to shut
Twist
down.
! Do not install in:
— Places where it could injure the driver or
— Places where it may interfere with the dri-
! Install tapping screws in such a way that the
screw tip does not touch any wire. This is im-
portant to prevent wires from being cut by vi-
bration of the car, which can result in fire.
! Make sure that wires do not get caught in the
sliding mechanism of the seats or touch the
legs of a person in the vehicle as short-circuit
may result.
! When drilling to install the amplifier, always
confirm no parts are behind the panel and
protect all cables and important equipment
(e.g. fuel/brake lines, wiring) from damage.
! To ensure proper heat dissipation of the ampli-
fier, ensure the following during installation:
— Allow adequate space above the amplifier
— Do not cover the amplifier with a floor mat
! Protection function may activate to protect the
amplifier against overheating due to installa-
tion in locations where sufficient heat cannot
be dissipated, continuous use under high-vo-
lume conditions, etc. In such cases, the am-
plifier reduces the power output or shuts
down until it has cooled to a certain desig-
nated temperature.
! Place all cables away from hot places, such
as near the heater outlet.
En
Autogoods "130"
WARNING
passengers if the vehicle stops suddenly.
ver, such as on the floor in front of the dri-
ver's seat.
CAUTION
for proper ventilation.
or carpet.