Pioneer GM-A5702 Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Pioneer GM-A5702. Pioneer GM-A5702 16 stron. Bridgeable two-channel
Również dla Pioneer GM-A5702: Instrukcja obsługi (19 strony), Instrukcja obsługi (33 strony), Instrukcja obsługi (33 strony)

Drukuj stronę

1. Connecting the Speakers

Connecting the units

Connecting the speaker

output terminals

Use wire cutters or a utility knife to

strip the end of the speaker wires to ex-

pose about 10 mm of wire and then twist

the wire.

Attach lugs to wire ends.

Use pliers, etc., to crimp lugs to wires.

1 Lug (sold separately)

2 Speaker wire

Connect the speaker wires to the

speaker output terminals.

Fix the speaker wires securely with the term-

inal screws.

1 Terminal screws

2 Speaker wires

3 Speaker output terminals

Installation

Before installing the amplifier

! To ensure proper installation, use the supplied

parts in the manner specified. If any parts

other than those supplied are used, they may

damage internal parts of the amplifier, or be-

come loose causing the amplifier to shut

Twist

down.

! Do not install in:

— Places where it could injure the driver or

— Places where it may interfere with the dri-

! Install tapping screws in such a way that the

screw tip does not touch any wire. This is im-

portant to prevent wires from being cut by vi-

bration of the car, which can result in fire.

! Make sure that wires do not get caught in the

sliding mechanism of the seats or touch the

legs of a person in the vehicle as short-circuit

may result.

! When drilling to install the amplifier, always

confirm no parts are behind the panel and

protect all cables and important equipment

(e.g. fuel/brake lines, wiring) from damage.

! To ensure proper heat dissipation of the ampli-

fier, ensure the following during installation:

— Allow adequate space above the amplifier

— Do not cover the amplifier with a floor mat

! Protection function may activate to protect the

amplifier against overheating due to installa-

tion in locations where sufficient heat cannot

be dissipated, continuous use under high-vo-

lume conditions, etc. In such cases, the am-

plifier reduces the power output or shuts

down until it has cooled to a certain desig-

nated temperature.

! Place all cables away from hot places, such

as near the heater outlet.

Autogoods "130"

WARNING

passengers if the vehicle stops suddenly.

ver, such as on the floor in front of the dri-

ver's seat.

CAUTION

for proper ventilation.

or carpet.