Pioneer SA-7800 사용 설명서

{카테고리_이름} Pioneer SA-7800에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer SA-7800 12 페이지.
Pioneer SA-7800에 대해서도 마찬가지입니다: 서비스 매뉴얼 (30 페이지)

페이지 인쇄

STEREO AMPLIFIER

W) PIONEER'

A=7800

OPERATING

INSTRUCTIONS

These operating instructions are based on the model HG,

and they can be used for the S, S/G models. The differences

between the models are given below.

Power requirements

SA-7800/HG:

220V/240V

(switchable), 50Hz, 60Hz

SA-7800/S, S/G:

110V/120V/220V/240V

(switchable),

50Hz, 60Hz

NOTE:

Read

through

the section on the LINE

VOLTAGE

SE-

LECTOR

SWITCH on page 4 before using your amplifier

and check that the voltage selector switch is set correctly

for use in your area.

Power cords

SA-7800/HG:

This is configured as an AC inlet type.

Use a separate power cord in order to

connect the power supply.

SA-7800/S, S/G:

The

power

cord

is mounted

at the

rear.

Cabinet

SA-7800/HG, S:

Black cabinet

SA-7800/S/G:

Walnut grained finished cabinet.

Others

SA-7800/HG:

The DIN-type recording/playback

socket

is provided on the rear panel.

SA-7800/S, S/G:

The

outlets

are provided

on the

rear panel.

IMPORTANT

To prevent electric shock, do not remove cover. No user

FOR USE IN UNITED KINGDOM

AND

serviceable parts inside, refer servicing to qualified serv-

AUSTRALIA

ice personnel,

;

Always

disconnect

all the equipment

from

the mains

CAUTION

240V:

is facto-

ry adjusted

supply when

disconnecting

the signal leads. The power

cord

should

be connected

last, make

sure

that

the power

FOR

USE

UNITED

KINGDOM

switch is off. First, insert the female appliance connector

i n

thi

' n s

lead

]

of the

mains

cord

into

the AC

INLET,

then plug

the

aes

~ ae

cGy

ween

Henao

eae

cord to the wall socket, Be sure that the appliance con-

ile

ese peri oe ee Yellow:

Earth

nector is fully inserted into the AC INLET.

Pee

ee ae

Unplug the set from

the wall socket when it is not to be

Bes

tended

iod

ime,

Aah

;

WARNING

identifying

the terminals

in your plug proceed as fol-

lows.

THIS

APPARATUS

MUST

BE EARTHED.

The

wire

which

is coloured green-and-yellow

must

connected

to the terminal which

is marked with the let-

ter E or with the safety earth symbol -& or coloured

x OR

YOUR

SAFETY

green or green-and-yellow.

1. Insert this plug only into effectively earthed three-pin

The

wire

which

is coloured

blue must

be connected

plug-socket outlet.

the terminal which is marked with the letter N or colour-

2. If any doubt exists regarding the earthing, consult a

ed black,

qualified electrician.

The wire which is coloured brown must be connected to

3, Extension cords, if used, must be three-core correctly

the terminal which is marked with the letter L or colour-

wired.

ed red.