Ariston AW122 관리, 사용 및 설치 책자 - 페이지 16

{카테고리_이름} Ariston AW122에 대한 관리, 사용 및 설치 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston AW122 20 페이지. Washer / washer-dryer combo
Ariston AW122에 대해서도 마찬가지입니다: 관리, 사용 및 설치 책자 (20 페이지), 수리 매뉴얼 (20 페이지), 빠른 매뉴얼 (21 페이지)

페이지 인쇄

Installation Instructions

WARNING

EXCESSIVE WEIGHT HAZARD

Use two or more people to move

and install the washer-dryer.

Failure to do so can result in back

or other injury

Remove the Transit Screws/Spacers

First, position the washer so that the rear of the unit is

within approximately 3 feet (90 cm) of the ﬁnal location.

There are 4 bolts in the rear panel of the washer that sup-

port the suspension system during transportation.

1. Using a wrench, loosen each of the bolts.

2. Once loosened, pull out the bolt, including the rubber

grommet and the plastic spacer covering the bolt.

3. Once all 4 bolts are removed,

close the holes with the transit

bolt hole plugs (provided).

4. Keep the bolts, rubber

grommets and plastic spacers in

a safe place. These items should

be reinstalled if the machine is

transported in the future.

IMPORTANT!

Transit Screws/Spacers must be removed

before use.

Route the Drain Hose

Proper routing of the drain hose protects your ﬂoors from

damage due to water leakage. Carefully read and follow

these instructions.

The drain hose is connected to the washer. To prevent

drain water from going back into the washer:

• Do not straighten the drain hose, and do not force

excess drain hose into the standpipe. Hose should be

secure, but loose enough to provide a gap for air.

• When routing the drain hose through cabinets or walls,

use a protective material such as electrical tape to cover

sharp edges that could damage the hose.

Drain Hose

Connect the Inlet Hoses

Before connecting any hoses, run the faucets until the

water is clear to remove any debris. Make sure the drum is

empty. Please use the new hoses supplied. Old hoses may

cause leaks due to worn out washers or may be split due to

water pressure.

1. Connect the angled ends of the hoses to the inlet

valves at the back of the machine (20mm threads).

Screw on the couplings BY HAND until they are seated

on each gasket.