Ariston AW122 Handleiding voor verzorging, gebruik en installatie - Pagina 16
Blader online of download pdf Handleiding voor verzorging, gebruik en installatie voor {categorie_naam} Ariston AW122. Ariston AW122 20 pagina's. Washer / washer-dryer combo
Ook voor Ariston AW122: Handleiding voor verzorging, gebruik en installatie (20 pagina's), Reparatiehandleiding (20 pagina's), Beknopte handleiding (21 pagina's)
Pagina afdrukken
Installation Instructions
!
WARNING
EXCESSIVE WEIGHT HAZARD
Use two or more people to move
and install the washer-dryer.
Failure to do so can result in back
or other injury
Remove the Transit Screws/Spacers
First, position the washer so that the rear of the unit is
within approximately 3 feet (90 cm) of the final location.
There are 4 bolts in the rear panel of the washer that sup-
port the suspension system during transportation.
1. Using a wrench, loosen each of the bolts.
2. Once loosened, pull out the bolt, including the rubber
grommet and the plastic spacer covering the bolt.
3. Once all 4 bolts are removed,
close the holes with the transit
bolt hole plugs (provided).
4. Keep the bolts, rubber
grommets and plastic spacers in
a safe place. These items should
be reinstalled if the machine is
transported in the future.
IMPORTANT!
Transit Screws/Spacers must be removed
before use.
16
Route the Drain Hose
Proper routing of the drain hose protects your floors from
damage due to water leakage. Carefully read and follow
these instructions.
The drain hose is connected to the washer. To prevent
drain water from going back into the washer:
• Do not straighten the drain hose, and do not force
excess drain hose into the standpipe. Hose should be
secure, but loose enough to provide a gap for air.
• When routing the drain hose through cabinets or walls,
use a protective material such as electrical tape to cover
sharp edges that could damage the hose.
Drain Hose
Connect the Inlet Hoses
Before connecting any hoses, run the faucets until the
water is clear to remove any debris. Make sure the drum is
empty. Please use the new hoses supplied. Old hoses may
cause leaks due to worn out washers or may be split due to
water pressure.
1. Connect the angled ends of the hoses to the inlet
valves at the back of the machine (20mm threads).
Screw on the couplings BY HAND until they are seated
on each gasket.