Pioneer DVD-V7200 네트워크 매뉴얼 - 페이지 11
{카테고리_이름} Pioneer DVD-V7200에 대한 네트워크 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer DVD-V7200 24 페이지. Industrial dvd-video player
Pioneer DVD-V7200에 대해서도 마찬가지입니다: 사용 설명서 (46 페이지), 업그레이드 정보 (1 페이지), 명령 목록 (3 페이지), 소프트웨어 설명서 (1 페이지), 뉴스레터 (1 페이지), 사양 (3 페이지)
페이지 인쇄
3.3
Command and Status
The computer transmits a command to the DVD-V7200 and the player
responds with the message, 'execution complete'.
Example
COMPUTER
(1) "Search to Frame 1000"
(4) "Play to Frame 2000"
NOTE: The length of a command string is limited to 32 characters. Please
refer to the COMMAND STRUCTURE segment for additional information.
When using a computer to control the DVD-V7200 player, follow the
command protocols listed below:
ASCII character codes are used for the actual commands and status
response
Command mnemonic is expressed as two (2) ASCII characters
Uppercase letters are recommended; however, usually there are no
distinctions between the use of uppercase or lowercase letters
Some commands require an argument, (e.g. chapter number or
speed)
Use a command as the terminator of the argument
The player executes a command as soon as the carriage return <CR> is
received. The <CR> acts as the command line terminator.
Example
CH<CR>
10SE<CR>
The player has a command buffer, which stores a command string of up to
32 characters in length.
Example
10SE 20PL<CR>
The command string enters into the buffer with the left character and
continues sequentially from left to right. When the
commands are executed sequentially beginning with the first command in
the buffer. In the example above, the first command is 10SE.
:
Set chapter for address mode
:
Search to chapter 10
:
Search to chapter 10 then play to 20
- 5 -
DVD-V7200 Upload/Download
DVD-V7200
(2) Search Execution
(3) Complete
(5) Play Execution
(6) Complete
is entered, the
<CR>