Pioneer PDP-S55-LR 사용 설명서 - 페이지 9
{카테고리_이름} Pioneer PDP-S55-LR에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer PDP-S55-LR 41 페이지. Pioneer speaker system operating instructions
Pioneer PDP-S55-LR에 대해서도 마찬가지입니다: 서비스 매뉴얼 (3 페이지)
페이지 인쇄
3 Loosely screwing the screws (M5) into place on
the top attachment pieces (2 locations).
Note:
To install the Plasma Display on a wall, first attach the
attachment pieces to the Plasma Display then install it on
the wall. After installing the Plasma Display on the wall, it
may be impossible to tighten the screws on the
attachment pieces.
4 Attaching the screws (M5) that have been
loosely screwed into place on the hooks on top
of the speakers. Loosely screw the screws (M5)
into place with the screw holes on the
attachment pieces on the bottom aligned with
the holes in the hooks on the bottom of the
speakers.
5 Tighten the screws just inserted firmly into
place (4 locations).
¶ Tighten the screws while pushing the speakers lightly
against the Plasma Display. Check to be sure that all
four screws have been screwed firmly into place.
¶ If there is a large gap between the Plasma Display
and the speakers, adjust them after slightly loosening
the screws that were tightened in step 2. After
adjustment, re-tighten the screws.
¶ To install the Plasma Display on a wall, it is
recommended that you first remove the speaker
units, then after the Plasma Display has been
installed on the wall, re-attach the speaker units to
the Plasma Display.
Warning
¶ Never hold the speakers when speakers are
attached to the monitor to move the monitor.
Doing so might result in the monitor falling, and
this in turn might result in bodily injury.
¶ Firmly tighten the screws. The speakers may fall
causing injuries.
English
9