Pioneer S-7EX XTW/E 사용 설명서 - 페이지 5

{카테고리_이름} Pioneer S-7EX XTW/E에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer S-7EX XTW/E 24 페이지. Ex series
Pioneer S-7EX XTW/E에 대해서도 마찬가지입니다: 카탈로그 (20 페이지), 브로셔 및 사양 (16 페이지), 서비스 매뉴얼 (10 페이지)

페이지 인쇄

Removing the grille

Loosen, then remove the finishing screws from the

four corners on the front of the grille.

After detaching the grille, remove the fastening

screws from the four holes on the front of the speaker.

Optionally, you can insert the supplied caps into the holes.

• Do not use a screwdriver (or hex wrench) to tighten the

screws. Overtightening could damage the speaker.

• When not in use, store the screws with these operating

instructions for safekeeping.

Magnetic shielding

This speaker system is magnetically shielded. However,

depending on the installation location, color distortion may

occur if the speaker system is installed extremely close to the

screen of a television set.

If this happens, turn off the television, then turn it on again

after 15 min to 30 min. If the problem persists, place the

speaker system away from the television set.

Cleaning the speaker cabinet

With normal use, wiping with a dry cloth should be sufficient

to keep the cabinet clean. If necessary, clean with a cloth

dipped in a neutral cleanser diluted five or six times with

water, and wrung out well. Do not use furniture wax or

cleansers.

Never use thinners, benzine, insecticide sprays or other

chemicals on or near this unit since these will corrode the

surfaces.

Specifications

Enclosure ......................................... Bass-reflex bookshelf type

Configuration ...................................................................... 3-way

Woofer .............................................. 18 cm (7

Tweeter ........ 14 cm (5

inch) cone / 3.5 cm (1

Nominal impedance ............................................................. 6 Ω

Frequency response ........................................ 34 Hz to 100 kHz

Sensitivity ........................................................... 89.5 dB (2.83 V)

Maximum input power ..................................................... 200 W

Exterior dimensions

................................. 820 (W) mm × 291 (H) mm × 425 (D) mm

(W) in. x 11

Weight ................................................................... 39 kg / 86 lbs.

Supplied accessories

Speaker base .................................................................... ×1

Speaker spikes (with attached nuts) .............................. ×4

Spike bases ...................................................................... ×4

Fastening screws (for grille) ............................................ ×4

Finishing screws (for grille) ............................................. ×4

Caps ................................................................................ ×10

Grille .................................................................................. ×1

Operating instructions .................................................... ×1

• Specifications and design subject to possible modifica-

tion without notice, due to improvements.

• Real, natural wood is used in the construction of the

speaker system cabinets. They feature a wonderful color

and depth that is much more attractive than plastic

veneers and similar materials.

No two pieces of natural wood are exactly alike. Keep

this point in mind as you enjoy these speakers.

With the cooperation of AIR Studios, this

speaker has been designated AIR Studios

Monitor Reference.

is a trademark placed on a product with

Pioneer's Phase Control technology.

This technology enables high-grade sound

reproduction through each component by

improving overall phase matching.

(magnetically shielded)

inch) cone ×2

inch) dome

(H) in. x 16

(D) in.