Cruza XR-300 사용자 설명서 - 페이지 11

{카테고리_이름} Cruza XR-300에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cruza XR-300 13 페이지. Electric scooter

The belt will come adjusted from the factory. However, it may be necessary to

adjust the belt from time to time. The belt must be well aligned onto the

sprockets in order to avoid uneven wear. This will result in shortened belt life.

How tight should the belt be?

 If the belt is skipping or jumping on the sprockets, this is too

loose and may be harmful.

 The correct tension is achieved by adjusting the belt from its

loose position to when it becomes lightly tense.

 Adjusting the belt too tight may cause the belt to break

 Proper tension is tested by placing pressure in the center of the

belt, between the sprockets and having ¼ to 3/8 inch movement

only.

To tighten the belt:

Slightly loosen the two axle

bolts on both sides of the rear

wheel. (Fig.9). Then slowly

adjust the two adjusting screws

on each side of the rear tire

(Fig.10) until belt reaches the

proper tension.

Rotate the rear wheel to make

sure the belt is aligned.

Finally, lock and tighten the

rear axle bolts prior to riding.

Page11