Pioneer PDP 502MX 매뉴얼 - 페이지 3

{카테고리_이름} Pioneer PDP 502MX에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer PDP 502MX 11 페이지. Rs-232c control for plasma display monitor, serial commands and protocol
Pioneer PDP 502MX에 대해서도 마찬가지입니다: 브로셔 및 사양 (8 페이지), 뉴스레터 (1 페이지), 뉴스레터 (1 페이지), 사용 설명서 (44 페이지)

페이지 인쇄
Pioneer PDP 502MX 매뉴얼
5.5.2 Interface
1) Connector
D-sub 9 pins
2) Pin Assignment
Pin No.
Signal
1
NC (not connected)
2
TXD (Transmit Data)
3
RXD (Receive Data)
4
NC (not connected)
5
GND
6
NC (not connected)
7
NC (not connected)
8
RTS (Return To Send)
9
NC (not connected)
3) Baud Rate
4800 bps (standard)
(switch-able to 1200, 2400, 9600, 19200 bps)
(NOTE) Set the baud rate to match that of the computer presently in use. Moreover, in the case that the RS-232C
cable is very long, we recommend that you make the baud rate lower.
4) Data Format
Start: 1-bit
Data: 8-bit
Parity: 0 (no parity)
Stop: 1-bit
5) Connection
Control PC (PC-98)
RXD 3
TXD 2
CTS 5
GND 7
* D-sub 9-pin/D-sub 25-pin conversion tables are now available
on the market.
6) Protocol
From computer to plasma display
(1) When transmitting commands individually
STX (02 hex)
ID (2 Byte)
(2) When transmitting commands in batches (up to max. 3 commands) ....
STX (02 hex)
ID (2 Byte)
(3) When transmitting direct numeric commands
STX (02 hex)
ID (2 Byte)
(NOTE) • Transmit <PON> and <POF> commands
one by one. (Allow an interval of three or
more seconds between commands.)
• Transmit an input switching command (IN
1-4) and <AJY> command, allowing
sufficient time between them.
• Allow an interval of approximately three or
more seconds between input switching
commands (IN 1-4).

PLASMA DISPLAY

(PDP-502MX)
2
2 TXD
3
3 RXD
2
8 RTS
5 GND
COMMAND (3 Byte)
COMMAND (3 Byte)
COMMAND (3 Byte)
RS-232C Adjustment Mode
Control PC (IBM PC/AT)
RXD 2
TXD 3
CTS 8
GND 5
Straight Cable
ETX (03 hex)
COMMAND 3 Byte (ASCII)
ARGUMENT 3 Byte (ASCII)
(NOTE)
COMMAND (3 Byte)
COMMAND (3 Byte)
ARGUMENT (3 Byte)
ETX (03 hex)
Error Example 1)
STX
ID
Error Example 2)
STX
ID
Error Example 3)
STX
ID
1
5
6
9
PLASMA DISPLAY
(PDP-502MX)
2
2 TXD
3
3 RXD
2
8 RTS
5 GND
ETX (03 hex)
<PON>
<AJY>
<CNT>
<POF>
<PON>
ETX
<IN2>
<AJY>
<CNT>
ETX
ETX
115