Pioneer PDP 503CMX 사용 설명서 - 페이지 17
{카테고리_이름} Pioneer PDP 503CMX에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer PDP 503CMX 44 페이지. Pioneer 3rd, 4th % 5th generations plasma panel quick reference parts lists
Pioneer PDP 503CMX에 대해서도 마찬가지입니다: 기술 매뉴얼 (25 페이지), 빠른 참조 부품 목록 (12 페이지)
페이지 인쇄
Installation using the optional PIONEER stand or
installation bracket
÷ Please be sure to request installation or mounting of this unit
or the installation bracket by an installation specialist or the
dealer where purchased.
÷ When installing, be sure to use the bolts provided with the
stand or installation bracket.
÷ For details concerning installation, please refer to the
instruction manual provided with the stand or installation
bracket.
Installation using accessories other than the
PIONEER stand or installation bracket (sold
separately)
÷ When possible, please install using parts and accessories
manufactured by PIONEER. PIONEER will not be held
responsible for accident or damage caused by the use of parts
and accessories manufactured by other companies.
÷ For custom installation, please consult the dealer where the
unit was purchased, or a qualified installer.
b hole
a hole
b hole
b hole
Rear view diagram (PDP-503CMX)
a hole
b hole
b hole
Rear view diagram (PDP-433CMX)
Air vents (fan)
b hole
a hole
Center line
b hole
Air vents (fan)
a hole
Center line
b hole
Installation and Connections
Wall-mount installation of the unit
This unit has been designed with bolt holes for
wall-mount installation, etc. The installation holes that can
be used are shown in the diagram below.
÷ Be sure to attach in 4 or more locations above and
below, left and right of the center line.
÷ Use bolts that are long enough to be inserted 1/2 inch
(12 mm) to 11/16 inch (18 mm) into the main unit from
the attaching surface for both a holes and b holes.
Refer to the side view diagram below.
÷ As this unit is constructed with glass, be sure to install
it on a flat, unwarped surface.
CAUTION
To avoid malfunction, overheating of this unit, and
possible fire hazard, make sure that the vents on the
main unit are not blocked when installing. Also, as hot
air is expelled from the air vents, be careful of
deterioration and dirt build up on rear surface wall, etc..
Main unit
Center line
b hole
1/2 inch (12 mm) to 11/16 inch (18 mm)
Side view diagram
CAUTION
Please be sure to use an M8 (Pitch = 1.25 mm)
bolt. (Only this size bolt can be used.)
CAUTION
This display unit weighs at least 67 lbs (30 kg)
Center line
and has little front-to-back depth, making it very
unstable when stood on edge. As a result, two
b hole
or more persons should cooperate when
unpacking, moving, or installing the display.
CAUTION
This unit incorporates a thin design. To ensure
safety if vibrated or shaken, please be sure to
take measures to prevent the unit from tipping
over.
Attaching surface
Installation
bracket, etc..
a hole
Bolt
1/2 inches (12 mm) to
11/16 inches (18 mm)
Bolt
b hole
11
En