Pioneer SD-T292 RD/Q1 사용 설명서 - 페이지 14

{카테고리_이름} Pioneer SD-T292 RD/Q1에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer SD-T292 RD/Q1 25 페이지. Hi-fi monitor receiver

페이지 인쇄

CHANNEL

SELECTION

FOR RECEPTION

CABLE (CATV) CHANNEL

SELECTION

1. Press the TV key (one of the Function selector keys).

Press

{

veces"

ls =|

winkeye

ale

'Gel-Gal|

2. Open the control panel door of the Hi-Fi Monitor Receiver

and set the CHANNEL PLAN selector switch to. "CATV."

CHANNEL PLAN

3. Direct Channel Selection

Enter the desired channel number from the 10 channel call

keys for channel selection of VHF channels (1 — 13}, mid-band

channels (A-6 to A-1, A to |) and super-band channel (J to

W). Operation of direct channel selection for cable channels is

the same as described in the preceding section, [OFF-THE-AIR

(TV) CHANNEL SELECTION] with the following exception:

Channel numbers 00, and 37 through 93 are unassigned. If

these numbers are selected the channel remains unchanged.

CABLE

(CATV) CHANNEL

ASSIGNMENT

CHANNEL.

10 Channel

cali keys

4. Preset Channel Selection

Those channels memorized

with the preset function can be

selected by the following means:

~ CHANNEL +

Press to select higher-numbered channels,

Press to select lower-numbered channels,

For details, refer to the section "CHANNEL MEMORY SETTING"

on page 16.

Channel number assignment for the cable tuning mode begins with 01 through 36, omits the unassigned numbers 37 through 93, then pro-

ceeds from 94 through 99. The specific channel number assignments and the corresponding alphabetical designation are shown below in

the channel table.

VHF L

MID

VHF

SUPER

UHF

2—6

7-13

14-69

A-6 (94)

A (14)

J (23)

(30)

A-5 (95)

Bs)

K (24)

R31)

2-6

A-4 (96)

c (16)

L (25)

S$ (32)

(sto)

A-3 (97)

ban

M26)

1133)

CATV

A-2 (98)

ej)

7-13 «|

NG?)

6] ea)

1-6

A-1 (99)

F (19)

0 (28)

V (35)

(HRC)

G (20)

Pi29)

Wi6)

H (21)

1 (22)

For example: Channel number "14" corresponds with mid-band cable channel "A."

NOTE:

Cable (CATV) services can vary from area to area. The channel number assignments shown in the channel table may not correspond with the channel numbers

used by your local cable company. Direct tuning to cable channels without the use of the cable company "converter" or "'preselector" will depend on the specif-

te channels in use by the cable company. Direct tuning te cable channels is limited to unencoded (unscrambled} channels only. Check your local cable company

compatibility requirements.