Pioneer SD-T292 RD/Q1 Instrukcja obsługi - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Monitor Pioneer SD-T292 RD/Q1. Pioneer SD-T292 RD/Q1 25 stron. Hi-fi monitor receiver
Drukuj stronę
CHANNEL
SELECTION
FOR RECEPTION
CABLE (CATV) CHANNEL
SELECTION
|
1. Press the TV key (one of the Function selector keys).
Press
{
veces"
ls =|
winkeye
ale
Ea
'Gel-Gal|
2. Open the control panel door of the Hi-Fi Monitor Receiver
and set the CHANNEL PLAN selector switch to. "CATV."
CHANNEL PLAN
3. Direct Channel Selection
Enter the desired channel number from the 10 channel call
keys for channel selection of VHF channels (1 — 13}, mid-band
channels (A-6 to A-1, A to |) and super-band channel (J to
W). Operation of direct channel selection for cable channels is
the same as described in the preceding section, [OFF-THE-AIR
(TV) CHANNEL SELECTION] with the following exception:
Channel numbers 00, and 37 through 93 are unassigned. If
these numbers are selected the channel remains unchanged.
CABLE
(CATV) CHANNEL
ASSIGNMENT
-
CHANNEL.
+
10 Channel
cali keys
4. Preset Channel Selection
Those channels memorized
with the preset function can be
selected by the following means:
~ CHANNEL +
Press to select higher-numbered channels,
Press to select lower-numbered channels,
For details, refer to the section "CHANNEL MEMORY SETTING"
on page 16.
Channel number assignment for the cable tuning mode begins with 01 through 36, omits the unassigned numbers 37 through 93, then pro-
ceeds from 94 through 99. The specific channel number assignments and the corresponding alphabetical designation are shown below in
the channel table.
VHF L
MID
VHF
SUPER
UHF
TV
2—6
=
7-13
=
14-69
A-6 (94)
A (14)
J (23)
(30)
A-5 (95)
Bs)
|
K (24)
R31)
2-6
A-4 (96)
c (16)
L (25)
S$ (32)
(sto)
A-3 (97)
ban
|
M26)
|
1133)
CATV
A-2 (98)
ej)
|
7-13 «|
NG?)
6] ea)
1-6
A-1 (99)
F (19)
|
|
0 (28)
|
V (35)
=|
|
(HRC)
G (20)
Pi29)
|
Wi6)
|
|
H (21)
1 (22)
For example: Channel number "14" corresponds with mid-band cable channel "A."
NOTE:
Cable (CATV) services can vary from area to area. The channel number assignments shown in the channel table may not correspond with the channel numbers
used by your local cable company. Direct tuning to cable channels without the use of the cable company "converter" or "'preselector" will depend on the specif-
te channels in use by the cable company. Direct tuning te cable channels is limited to unencoded (unscrambled} channels only. Check your local cable company
compatibility requirements.
14
<ARB1184 >