Dinel CLS-23 사용 설명서 - 페이지 7

{카테고리_이름} Dinel CLS-23에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dinel CLS-23 18 페이지. Capacitive level sesors
Dinel CLS-23에 대해서도 마찬가지입니다: 매뉴얼 (20 페이지)

hen installing the sensor into the pipe it

is necessary to choose properly internal di-

ameter of the tube to ensure the inner walls

distances from the electrode to min. 5 mm.

n some cases sticy liuids liuids with low

dielectric constant is suitable to mount the

sensor in the knee tube.

Applies to: CLS 23_ 10, 11, 12, 20, 21

max.

min.

Fig. 4: Two state regulation by hysteresis setting

WRONG

CORRECT

Fig. 5: Long tting tubes in side wall mounting

hen installing the sensor in vertical position it can be used

for 2-state (LO-HI) level control between the min. and ma.

level. The position of the minimum and maimum level can be

changed by setting the sensor. luid changes reuire new set-

tings of the sensor

E Electrode length in mm

Applies to: CLS 23_ 20, 30 (only for electrically non-conductive liquids)

CORRECT

Fig. 3: Mounting in the pipe

Applies to: CLS 23_ 21 (for electrically conductive liquids)

WRONG

ensor installation close to inlet hole in a narrow

nec or using improper welding ange may result in

malfunction of the sensor.

uitable welding anges can be found in the inel

assortment types    see ccessories.

CORRECT

Applies to: All variants

CLS 23

 Dinel