Dinel CLS-23 사용 설명서 - 페이지 6
{카테고리_이름} Dinel CLS-23에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dinel CLS-23 18 페이지. Capacitive level sesors
Dinel CLS-23에 대해서도 마찬가지입니다: 매뉴얼 (20 페이지)
페이지 인쇄
6 . m
oUnting recommendation
level sensors can be ed in a vertical horiontal or bevelled position into the shell of the
vessel the storage tan for the ation console in the pit by screwing into the welding ange using
a ing nut or T process connection.
asic application recommendations are mentioned below.
During assembly into the metal tank or the storage tank, it is not necessary to separately ground the
base of the level sensor. In the case of installation in concrete tanks or silos, it is recommended to
install a level sensor on the auxiliary metal construction (console, cap, etc.) and to then connect it
using a permanently dipped metal item or with steel reinforcement in the concrete (armouring).
In the case of the reading of an aggressive medium, we recommend that the producer be consulted.
If the sensors are tted with protective caps at the ends of the electrodes, remove the
caps before commissioning.
d
Fig. 1: Vertical mounting
b
Fig. 2: Bypass measuring tube
Dinel
CLS 23
or top mounting vertical position it is necessary to eep the
distances from walls and from other sensors.
=
≥
+
c
10
50
k
E Electrode length in mm
ounting in a bypass measuring tube. e recommend to
eep the tube diameter.
=
≥
+
b
40
E Electrode length in mm
E
E
=
≥
+
d
40
40
E
20
All vertically mounted sensors
E
=
≥
+
k
20
20
Applies to: CLS 23_ 20, 21, 30
7