Dinel GPLS-25 Series 사용 설명서 - 페이지 6

{카테고리_이름} Dinel GPLS-25 Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dinel GPLS-25 Series 14 페이지. Thru-wall level switches
Dinel GPLS-25 Series에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지)

페이지 인쇄

7 . Electrical connection

THE TYPE OF SENSOR GPLS – 25N – _ - S

Positive pole (+U) of power supply is connected through a load (relay) to brown wire or pin

connector No. 1, negative pole is connected to while wire or pin connector No.3.

THE TYPE OF SENSOR GPLS – 25N – _ - P

Positive pole (+U) of power supply is connected to brown wire or pin connector No.1, negative

pole is connected to blue wire or pin connector No.3. Load (relay) is connected to black wire or

pin connector No.2.

The sensor GPLS-28 output is protected againts short circuits. Capacity loads and loads with

low sleep resistance (bulb) the sensor evaluation as a short circuit. In case of high ambient

electromagnetic interference, parallel conductors with power lines, or lines at distances greater than

30 m, we recommend to use shielded cable.

Electrical connection must be done in de-energized state!

For switching supply sources, it is necessary to check that the input is galvanically separated

from the network side and that they are fitted with a filter suppressing the conforming

interference (terminals + and – oscillate together towards the ground potential), or the

interference is removed in another manner.

Connection scheme of sensor

with "S" type output

Connection scheme of sensor

with "PNP" type output

Legend:

(1) – Terminals number for variants with connector

BN – Brown

WH – White

BU – Blue

GPLS-25