Ariston 200D 설치, 사용, 유지보수 지침 - 페이지 2

{카테고리_이름} Ariston 200D에 대한 설치, 사용, 유지보수 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston 200D 33 페이지. Heat pump water heater

페이지 인쇄

GENERAL SAFETY INSTRUCTIONS

1. Read the instructions and warning in this

manual carefully, they contain important

information regarding safe installation, use

and maintenance. This manual is an integral

part of the product. Hand it on to the next

user/owner in case of change of property.

2. The manufacturer shall not liable for any inju-

ry to people, animals or damage to property

caused by improper, incorrect or unreasona-

ble use or failure to follow the instructions re-

ported in this publication.

3. Installation and maintenance must be per-

formed by professionally qualifi ed personnel

as specifi ed in the relative paragraphs. Only

use original spare parts. Failure to observe

the above instructions can compromise the

safety of the appliance and relieves the man-

ufacturer of any liability for the consequences.

4. DO NOT leave the packaging materials (sta-

ples, plastic bags, expanded polystyrene, etc.)

within the reach of children they can cause

serious injury.

5. The appliance may not be used by persons

under 8 years of age, with reduced physical,

sensory or mental capacity, or lacking the

requisite experience and familiarity, unless

under supervision or following instruction in

the safe use of the appliance and the haz-

ards attendant on such use. DO NOT per-

mit children to play with the appliance. User

cleaning and maintenance may not be done

by unsupervised children.

6. DO NOT touch the appliance when barefoot

or if any part of your body is wet.

7. Before using the device and after routine or

extraordinary maintenance, we recommend fi

lling the appliance's tank with water and drain-

ing it completely to remove any residual impu-

rities.

8. If the appliance is equipped with a power cord,

the latter may only be replaced by an author-

ised service centre or professional technician.

2 /EN

9. It is mandatory to screw o the water inlet pipe

of the unit a safety valve in accordance with

national regulations. In countries which have

enacted EN 1487, the safety group must be

calibrated to a maximum pressure of 0,7 MPa

and include at least a cock, check valve and

control, safety valve and hydraulic load cut-

out.

10. Do not tamper with the overpressure safety

device (valve or safety group), if supplied to-

gether with the appliance; trip it from time to

time to ensure that it is not jammed and to re-

move any scale deposits.

11. It is normal water drips from the overpressure

safety device when the appliance is heating.

For this reason, the drain must be connected,

always left open to the atmosphere, with a

drainage pipe installed in a continuous down-

ward slope and in a place free of ice.

12. Make sure you drain the appliance and dis-

connect it from the power grid when it is out

of service in an area subject to subzero tem-

peratures.

13. Water heated to over 50 °C can cause imme-

diate serious burns if delivered directly to the

taps. Children, disabled persons and the aged

are particularly at risk. We recommend install-

ing a thermostatic mixer valve on the water

delivery line, marked with a red collar.

14. Do not leave fl ammable materials in contact

with or in the vicinity of the appliance.

15. Do not place anything under the water heater

which may be damaged by a leak..

16. The water heating heat pump is supplied with

a sufficient amount of R134a or R513a refrig-

erant for its operation. This refrigerant fluid

does not damage the atmosphere's ozone

layer, is not flammable and does not cause ex-

plosions; however any maintenance activities

or work on the refrigerant circuit must only be

carried out by authorised personnel and with

the use of suitable equipment.