Aeotec MULTISENSOR 6 사용자 설명서 - 페이지 5

{카테고리_이름} Aeotec MULTISENSOR 6에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec MULTISENSOR 6 13 페이지. Z-wave water and flood sensor
Aeotec MULTISENSOR 6에 대해서도 마찬가지입니다: 사용자 설명서 (13 페이지), 매뉴얼 (3 페이지), 사용자 설명서 (8 페이지), 매뉴얼 (10 페이지)

페이지 인쇄

Multisensor 6 user guide : Aeotec Group

Using an existing gateway:

You may need to refer to your gateway's method of including devices if you do not know how to pair a Z-Wave

device.

1. Put your primary Z-Wave gateway into pair mode, your Z-Wave gateway should conﬁrm that it is waiting to add

a new device

2. Press the Action Button on your MultiSensor.

3. The LED on MultiSensor will blink Green rapidly, followed by a solid Green LED for 1 second for successful

inclusion, or a solid red LED for 1 second for a failed inclusion.

SmartThings pair steps.

Connect MultiSensor 6 to SmartThings

setup-multisensor-6-zw100-with-smartthings-)

available at that link.

Choosing a Location for your MultiSensor.

MultiSensor 6 can bring its intelligent readings to many locations of your home. Before deciding on a location, there

are some things you should ﬁrst consider.

MultiSensor 6's motion sensor uses light and heat readings to determine motion; sudden light and heating changes

can impact the sensor's quality of motion readings. As such, your sensor should not be installed in areas of artiﬁcial

temperature change. Thus, when selecting a location, avoid placing it beside or near air conditioners, humidiﬁers,

and heaters, and avoid positioning it directly opposite a window or direct sunlight.

If your MultiSensor 6 will be powered by batteries, you should avoid installing it in a location where the temperature

can drop below 0°C / 32°F - this is below the batteries' working point. Selecting a location for your sensor also

depends on the layout of any area that you want monitoring. Whatever the room or area, please ensure that it ﬁts with

your sensor's eﬀective motion sensing range as described in the following diagrams. If installing MultiSensor 6 on a

ceiling it can take measurements within a 3 x 3 x 6 metre / 10 x 9 x 18 feet range:

Note: The wider side of the oval is in the direction of the battery placement from + to -

https://aeotec.freshdesk.com/support/solutions/articles/6000057073-multisensor-6-user-guide-

(https://aeotec.freshdesk.com/support/solutions/articles/6000231561-

using SmartThings' Connect app, follow the dedicated instructions

29-09-2020 17:00

Pagina 5 van 13