Aeotec MULTISENSOR 6 Podręcznik użytkownika - Strona 5
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Akcesoria Aeotec MULTISENSOR 6. Aeotec MULTISENSOR 6 13 stron. Z-wave water and flood sensor
Również dla Aeotec MULTISENSOR 6: Podręcznik użytkownika (13 strony), Podręcznik (3 strony), Podręcznik użytkownika (8 strony), Podręcznik (10 strony)
Drukuj stronę
Multisensor 6 user guide : Aeotec Group
Using an existing gateway:
You may need to refer to your gateway's method of including devices if you do not know how to pair a Z-Wave
device.
1. Put your primary Z-Wave gateway into pair mode, your Z-Wave gateway should confirm that it is waiting to add
a new device
2. Press the Action Button on your MultiSensor.
3. The LED on MultiSensor will blink Green rapidly, followed by a solid Green LED for 1 second for successful
inclusion, or a solid red LED for 1 second for a failed inclusion.
SmartThings pair steps.
Connect MultiSensor 6 to SmartThings
setup-multisensor-6-zw100-with-smartthings-)
available at that link.
Choosing a Location for your MultiSensor.
MultiSensor 6 can bring its intelligent readings to many locations of your home. Before deciding on a location, there
are some things you should first consider.
MultiSensor 6's motion sensor uses light and heat readings to determine motion; sudden light and heating changes
can impact the sensor's quality of motion readings. As such, your sensor should not be installed in areas of artificial
temperature change. Thus, when selecting a location, avoid placing it beside or near air conditioners, humidifiers,
and heaters, and avoid positioning it directly opposite a window or direct sunlight.
If your MultiSensor 6 will be powered by batteries, you should avoid installing it in a location where the temperature
can drop below 0°C / 32°F - this is below the batteries' working point. Selecting a location for your sensor also
depends on the layout of any area that you want monitoring. Whatever the room or area, please ensure that it fits with
your sensor's effective motion sensing range as described in the following diagrams. If installing MultiSensor 6 on a
ceiling it can take measurements within a 3 x 3 x 6 metre / 10 x 9 x 18 feet range:
Note: The wider side of the oval is in the direction of the battery placement from + to -
https://aeotec.freshdesk.com/support/solutions/articles/6000057073-multisensor-6-user-guide-
(https://aeotec.freshdesk.com/support/solutions/articles/6000231561-
using SmartThings' Connect app, follow the dedicated instructions
29-09-2020 17:00
Pagina 5 van 13