Aeotec Water Sensor 7 Pro 사용자 설명서 - 페이지 7
{카테고리_이름} Aeotec Water Sensor 7 Pro에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec Water Sensor 7 Pro 14 페이지. Water sensor
Aeotec Water Sensor 7 Pro에 대해서도 마찬가지입니다: 매뉴얼 (3 페이지), 빠른 시작 매뉴얼 (8 페이지), 사용자 설명서 (9 페이지), 사용자 설명서 (13 페이지), 사용자 설명서 (9 페이지)
페이지 인쇄
3 QUICK START
Important safety information
3.1
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may
violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting
from failure to comply with the instructions in this manual or any other material. Use this equipment only for its
intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near
open heat sources.
Optimally placing the product
3.2
This is a secure Alarm Sensor. To run this device please insert fresh 1 * 1/2 AA batteries. Please make sure the internal
battery is fully charged. The DSK for the S2 inclusion can be found inside the sensors packaging.
If your Z-Wave gateway supports SmartStart: scan the QR code on Door / Window Sensor 7 Pro using the gateway's
app. Your sensor will join your Z-Wave network automatically.
How to install the product
3.3
The sensor can be mounted either on the moving part or on the fixed part of a door or a window. Mounting can be
accomplished either using the tape by peeling off the protection foil or using two screws with the holes inside the
battery compartment. If the tilt detection on a window (only normal windows, no roof windows) shall be used the
sensor device must be placed on the moving part of the window and the magnet on the window frame.
The sensor comes with two types of magnets:
• The standard magnet covered by plastic part, mountable beside the sensor. Make sure the two
indicating lines on sensor enclosure and magnet are opposite to each other. The image on the right-
hand side shows the position of magnet and sensor body.
• A slim naked magnet to be mounted behind the sensor in case the sensor body is placed on the
side of a window.
• To use the tilting function, the opening angle of the window must be at least 5°.
For German-style windows where the window sits on top of the window frame
mounting on the side of the window is highly recommended. If no tilting detection
is used, the sensor can be placed on any position of the door or the window. In case
tilting detection is desired the sensor should be placed on the upper side of the
window.
How to add the product
3.4
The following will step you through adding the product to your Z-Wave network.
1. Open the housing.
2. Remove the battery protection.
3. Press the tamper on the side of the appliance three times quickly.
If your Z-Wave gateway supports SmartStart: scan the QR code on Door / Window Sensor 7 Pro using the gateway's
app. Your sensor will join your Z-Wave network automatically.
AEOTEC User Manual
Page 4