Aeotec ZW187 사용자 설명서 - 페이지 6

{카테고리_이름} Aeotec ZW187에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec ZW187 9 페이지. Recessed door sensor gen7
Aeotec ZW187에 대해서도 마찬가지입니다: 매뉴얼 (11 페이지)

Recommended drill bit size should be: 20 - 21mm in size.

Step 2 - Drill for Magnet piece.

Drill a corresponding hole in your door. The hole should be 15mm deep. As stated, the position of this hole should

align exactly with the hole you just created in the doorframe. Again, use a 19mm wide drill bit.

Unlike the main unit, 19mm drill bit should be used.

With your door and door frame prepared and the drill holes created, it's now time to mount both parts of your

Recessed Door Sensor.

Step 3

Insert Main Sensor into the hole you created in the door frame then secure it using two screws.

Step 4

Place a small amount of white glue (PVA) inside the hole you created for Magnetic Sensor. Then, place the sensor

over and into the hole. Next, insert it by tapping gently on it with a rubber hammer.