Aeotec ZWA011 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} Aeotec ZWA011에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec ZWA011 11 페이지.
Aeotec ZWA011에 대해서도 마찬가지입니다: 사용자 설명서 (9 페이지)

Inclusion/Exclusion

On factory default the device does not belong to any Z-Wave network. The device needs to be added to

an existing wireless network to communicate with the devices of this network. This process is

called Inclusion.

Devices can also be removed from a network. This process is called Exclusion. Both processes are

initiated by the primary controller of the Z-Wave network. This controller is turned into exclusion

respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right

on the device.

Inclusion

1. Open the housing.

2. Remove the battery protection.

3. Press the tamper on the side of the appliance three times quickly.

Exclusion

1. Open the housing.

2. Press the tamper on the side of the appliance three times quickly.

Product Usage

Once installed the sensor will report "open" and "close" status changes to a central Z-Wave controller

using notification commands. Additionally, the sensor can directly control other devices using association

group 2. The device is protected by a tamper switch.

Link testing

When activated by configuration parameter #5 the device can perform a link test. Double-clicking the

tamper will start the process. As a result, the GREEN LED will blink two times in case of success and the

RED LED will blink two times in case of failure.

Notifications

The device sends the following notifications to the central controller:

Window Opened(0x06 - 0x16)



Window Closed(0x06 - 0x17)



Tamper Removed(0x07 - 0x03)



The Node Information Frame (NIF) is the business card of a Z-Wave device. It contains information about

the device type and the technical capabilities. The inclusion and exclusion of the device is confirmed by

sending out a Node Information Frame. Beside this it may be needed for certain network operations to

send out a Node Information Frame. To issue a NIF execute the following action: Press the tamper once

Quick trouble shooting

Here are a few hints for network installation if things don't work as expected.

1. Make sure a device is in factory reset state before including. In doubt exclude before include.