Aeotec ZWA011 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Aeotec ZWA011에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec ZWA011 11 페이지.
Aeotec ZWA011에 대해서도 마찬가지입니다: 사용자 설명서 (9 페이지)

2. If inclusion still fails, check if both devices use the same frequency.

3. Remove all dead devices from associations. Otherwise you will see severe delays.

4. Never use sleeping battery devices without a central controller.

5. Dont poll FLIRS devices.

6. Make sure to have enough mains powered device to benefit from the meshing

Firmware-Update over the Air

This device is capable of receiving a new firmware 'over the air'. The update function needs to be

supported by the central controller. Once the controller starts the update process, perform the following

action to confirm the firmware update: Wake Up the device by removing the cover. Then hit the tamper

switch once.

Z-Wave devices control other Z-Wave devices. The relationship between one device controlling another

device is called association. In order to control a different device, the controlling device needs to maintain

a list of devices that will receive controlling commands. These lists are called association groups and

they are always related to certain events (e.g. button pressed, sensor triggers, ...). In case the event

happens all devices stored in the respective association group will receive the same wireless command

wireless command, typically a 'Basic Set' Command.

Association Groups:

Group Number

Z-Wave products are supposed to work out of the box after inclusion, however certain configuration can

adapt the function better to user needs or unlock further enhanced features.

IMPORTANT: Controllers may only allow configuring signed values. In order to set values in the range

128 ... 255 the value sent in the application shall be the desired value minus 256. For example: To set a

parameter to 200 i t may be needed to set a value of 200 minus 256 = minus 56. In case of a two byte

value the same logic applies: Values greater than 32768 may needed to be given as negative values too.

Parameter 3: Door/window state

This parameter allows to set in what state is door/window when the magnet is close to the sensor.

Size: 1 Byte, Default Value: 0

Maximum

Description

Nodes

Lifeline

Control devices when a magnet is tripped.

Sends out alarm message when a magnet is tripped

Sends alarm messages when tamper is tripped