Aeotec ZWA011 사용자 설명서 - 페이지 3

{카테고리_이름} Aeotec ZWA011에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec ZWA011 9 페이지.
Aeotec ZWA011에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (11 페이지)

18/06/2021

Quick Start

Pre-Installation of Door / Window Sensor 7 Basic.

Open the cover by pressing the clip on the side and pulling the cover upwards.

Insert a fresh 1 * 1/2 AA battery, but pay attention to the polarity

Install your Door / Window Sensor 7.

The sensor can be mounted either on the moving part or on the fixed part of a door or a window. Mounting can be

accomplished either using the tape by peeling off the protection foil or using two screws with the holes inside the battery

compartment. If the tilt detection on a window (only normal windows, no roof windows) shall be used the sensor device

must be placed on the moving part of the window and the magnet on the window frame. The sensor comes with two types

of magnets:

The standard magnet covered by the plastic part, mountable beside the sensor. Make sure the two indicating lines

on sensor enclosure and magnet are opposite to each other. The image on the right-hand side shows the position

of magnet and sensor body.

A slim "naked" magnet to be mounted behind the sensor in case the sensor body is placed on the side of a window.

For German-style windows where the window sits on top of the window frame mounting on the side of the window

is highly recommended. The sensor can be placed on any position of the door or the window.

https://help.aeotec.com/support/solutions/articles/6000230382-door-window-sensor-7-basic-user-guide-zwa011-zwa041-

Aeotec Door Window Sensor 7 Basic guide : Aeotec Help Desk

3/9