Aeotec ZWA011 Podręcznik użytkownika - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Akcesoria Aeotec ZWA011. Aeotec ZWA011 9 stron.
Również dla Aeotec ZWA011: Skrócona instrukcja obsługi (11 strony)

Drukuj stronę
Aeotec ZWA011 Podręcznik użytkownika
18/06/2021

Quick Start

Pre-Installation of Door / Window Sensor 7 Basic.
Open the cover by pressing the clip on the side and pulling the cover upwards.
Insert a fresh 1 * 1/2 AA battery, but pay attention to the polarity
Install your Door / Window Sensor 7.
The sensor can be mounted either on the moving part or on the fixed part of a door or a window. Mounting can be
accomplished either using the tape by peeling off the protection foil or using two screws with the holes inside the battery
compartment. If the tilt detection on a window (only normal windows, no roof windows) shall be used the sensor device
must be placed on the moving part of the window and the magnet on the window frame. The sensor comes with two types
of magnets:
The standard magnet covered by the plastic part, mountable beside the sensor. Make sure the two indicating lines
on sensor enclosure and magnet are opposite to each other. The image on the right-hand side shows the position
of magnet and sensor body.
A slim "naked" magnet to be mounted behind the sensor in case the sensor body is placed on the side of a window.
For German-style windows where the window sits on top of the window frame mounting on the side of the window
is highly recommended. The sensor can be placed on any position of the door or the window.
https://help.aeotec.com/support/solutions/articles/6000230382-door-window-sensor-7-basic-user-guide-zwa011-zwa041-
Aeotec Door Window Sensor 7 Basic guide : Aeotec Help Desk
3/9