ABB ACH550 series 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} ABB ACH550 series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB ACH550 series 6 페이지. Pumpsave 4.1, energy savings calculator for pump drives
ABB ACH550 series에 대해서도 마찬가지입니다: 사용자 설명서 (14 페이지), 설치, 운영 및 유지보수 매뉴얼 (18 페이지)

페이지 인쇄

Step 3: Remove all control wire and fieldbus connection from terminals (you can leave any existing jumpers). Unscrew

the board enclosure mounting screw from upper right corner.

Step 4: At the bottom of the plastic board enclosure there will be two plastic tabs (on bottom left, one bottom right)

that should be pulled down to separate the enclosure. After they are pulled down, slowly separate the plastic board

enclosure housing about 1 -2 inches to see the two ribbon cables that must be detached from the unit to free the control

board (SMIO-01).

Step 5: After disconnecting the ribbon cables, remove the plastic board enclosure with the control board (SMIO-01) still

mounted in it. Remove the mounting screws from the front panel to complete removing the permanent fixtures keeping

the board in place in the plastic housing.

LVD-EOTKN094U-EN REV A

Effective: 2022-06-30