3Com Fast EtherLink XL PCI 10/100BASE-TX 빠른 시작 매뉴얼 - 페이지 9
{카테고리_이름} 3Com Fast EtherLink XL PCI 10/100BASE-TX에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com Fast EtherLink XL PCI 10/100BASE-TX 17 페이지. Fast ethernet switching modules for the corebuilder 9000 enterprise switch
페이지 인쇄
100BASE-FX and 10/100BASE-TX Fast Ethernet Switching Modules Quick Start Guide
7 Ensure that the module remains fully seated in the backplane connector
8 To secure the module front panel to the front of the chassis, tighten
Verifying Module
Operation
while you close the ejector handles. Push the end of each ejector
handle until the ejector handle locks into place.
the top and bottom spring-loaded screws to Torque Specification 3 to 5
inch-pounds.
CAUTION: To ensure adequate cooling airflow and continued product
safety agency compliance, install blank faceplates over all empty slots.
The 100BASE-FX and 10/100BASE-TX Fast Ethernet Switching Modules
contain LEDs that indicate the module and port status. Watch the
Module Status LED during system power-on to verify proper module
operation.
The power-on diagnostic test flash sequence is:
Green – Yellow – Green – Flashing Green (while running the diagnostic
test) – Green.
If the Module Status LED is Yellow after the diagnostics run, the
module has failed.
For the latest revision of diagnostics, only the Port Status LEDs are
tested, and the flashing sequence is: Yellow – Green – Off.
Table 2 describes the LED states and colors.
Table 2 Module and Port Status LED Indicators
.
LED
Module Status
Port Status
State and
Color
Description
Green
Power is on (normal operation).
Off
No power.
Flashing Green
Diagnostics or download in process.
Yellow
Diagnostic failure.
Green
Port is enabled and link is up.
Off
Port is disabled or link is down.
Flashing Green
Port is receiving packets.
Yellow
Malfunctioning module.
9