Ariston microGENUS 23 MFFI 설치 지침 매뉴얼 - 페이지 12

{카테고리_이름} Ariston microGENUS 23 MFFI에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston microGENUS 23 MFFI 25 페이지. Type c boilers
Ariston microGENUS 23 MFFI에 대해서도 마찬가지입니다: 사용자 설명서 (24 페이지), 서비스 지침 (28 페이지), 서비스 지침 (28 페이지)

페이지 인쇄

WIN

IPE

YSTEMS

. 2.11

2.10 R

OOM

HERMOSTAT

ONNECTION

To connect a room thermostat, it is necessary to:

1. - Open the control panel as indicated in section 3.3.

2.- Remove the link "A" from the terminal block on the reverse of the control panel.

3. - Insert the thermostat cable through the cable grommet and fasten it by means of the

cable-clamp provided.

4. - Then connect the thermostat wires to the terminal block.

5.- If a remote time clock is to be fitted, disconnect the integral time clock from the P.C.B.

6. - Using a volt-free switching time clock, connect the switching wires from the time clock

following points 1-4 above.

7. - If using an external time clock and room thermostat, these must be connected in

series as points 1-7 above.

Note: Only a two-wire type room thermostat can be used.

An anti-frost device is built-in to the appliance's electronic regulation

system.

In calculating the lengths of the pipes, the

maximum length "L" must also take into

consideration

exhaust/air intake end terminals, as well

as 90° elbows for coaxial systems.

The C52 types must comply with the

following requirements:

1 - The exhaust/ air intake pipes must

have the same diameter of

2 - If elbows are to be inserted into the

air intake and/or exhaust system, the

calculation of the overall length must

take into consideration the values for

each elbow, see the F

3 - The exhaust pipe must protrude by at

least 0.5 m above the top of the roof

in the event that it is located on the

opposite side to the side with the air

intake (this condition is not obligatory

when the air intake and exhaust are

located on the same side of the

building).

FU007A

Fo016A

the

values

CCESSORIES

ANUAL

for

the

80 mm.

L U E

I P E

Fo017A