Ariston microSYSTEM 15 RFFI 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Ariston microSYSTEM 15 RFFI에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston microSYSTEM 15 RFFI 20 페이지. Type c boilers
Ariston microSYSTEM 15 RFFI에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지), 서비스 지침 (24 페이지)

페이지 인쇄

2.4

ITING THE

PPLIANCE

132

. 2.1

2.7

OUNTING THE

2.8

LECTRICAL

. 2.2

This appliance is not suitable for outdoor installation.

The type C appliances (in which the combustion circuit, air vent intake and

combustion chamber are air-tight with respect to the room in which the

appliance is installed) can be installed in any type of room.

Secondary ventilation is not required with this boiler. The boiler must be installed on

a solid, non-combustible, permanent wall to prevent access from the rear.

60 mm

Fasten the boiler in place using the template and anchors supplied with the unit. It is

PPLIANCE

highly recommended that a spirit level be used to position the boiler so that it is

perfectly level.

For additional information, please consult the instructions contained in the

connection kit and the flue kit.

For safety purposes, have a competent person carefully check the electrical system

ONNECTION

in the property, as the manufacturer will not be held liable for damage caused by the

failure to earth the appliance properly or by anomalies in the supply of power. Make

sure that the residential electrical system is adequate for the maximum power

absorbed by the unit, which is indicated on the rating plate. In addition, check that the

section of cabling is appropriate for the power absorbed by the boiler.

MPORTANT

In the event that the power supply cord must be changed, replace it with one with the

same specifications. Make the connections to the terminal board located within the

control panel, as follows:

- The yellow-green wire should be connected to the terminal marked with the "

symbol;

2.5

EGEND

= Central Heating Flow (3/4")

= Gas Inlet (3/4")

= Central Heating Return (3/4")

mm = Clearances

450 mm

2.6

In order to allow for access to the interior of the boiler for

maintenance pur poses, the boiler must be installed in

compliance with the minimum clearances indicated in F

The boiler operates with alternating current, as indicated in the

technical information table in section 7, where the maximum

absorbed power is also indicated. Make sure that the

connections for the neutral and live wires correspond to the

indications in the diagram. The appliance electrical connections

are situated on the reverse of the control panel under the

inspection cover (see the ser vicing manual for fur ther

information)

VERALL

IMENSIONS

LEARANCES

. 2.1