Ariston UNO 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Ariston UNO에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston UNO 17 페이지. Wall-hung combination boiler

페이지 인쇄

400

123,5 123,5

200

. 2.0

450

*A minimum distance of 20mm is required to each side

. 2.1

of the boiler to allow removal of the outer casing.

220 mm

. 2.2

135

116

acqua

gas

120

250

85 mm

2.3

VERALL

IMENSIONS

EGEND

A = Central Heating Flow (3/4")

B = Domestic Hot Water Outlet (1/2")

C = Gas Inlet (3/4")

D = Domestic Cold Water Inlet (1/2")

E = Central Heating Return (3/4")

2.4

LEARANCES

In order to allow for access to the interior of the boiler for

maintenance pur poses, the boiler must be installed in

compliance with the minimum clearances indicated in F

2.5

OUNTING THE

Fasten the boiler in place using the template and anchors

supplied with the unit. It is highly recommended that a

spirit level be used to position the boiler so that it is

perfectly level.

For additional information, please consult the instructions

contained in the connection kit and the flue kit.

2.6

LECTRICAL

For safety purposes, have a competent person carefully

check the electrical system in the proper ty, as the

manufacturer will not be held liable for damage caused by

the failure to earth the appliance properly or by anomalies

in the supply of power. Make sure that the residential

electrical system is adequate for the maximum power

absorbed by the unit, which is indicated on the rating plate.

In addition, check that the section of cabling is appropriate

for the power absorbed by the boiler.

The boiler operates with alternating current, as indicated in

the technical information table in section 6, where the

maximum absorbed power is also indicated. Make sure

that the connections for the neutral and live wires

correspond to those indicated in the diagram. The

appliance electrical connections are situated on the

reverse of the control panel (see the servicing manual for

further information)

MPORTANT

In the event that the power supply cable must be changed,

replace it with one with the same specifications. Make the

connections to the terminal board located within the

control panel, as follows:

- The yellow-green wire should be connected to the

terminal marked with the "

use the ferrule mounted on the other supply cord;- The

blue wire should be connected to the terminal marked "N";

- The brown wire should be connected to the terminal

PPLIANCE

ONNECTION

" symbol; make sure to re-

. 2.1