Ariston FK 737 SCX AUS 사용 설명서 - 페이지 3

{카테고리_이름} Ariston FK 737 SCX AUS에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston FK 737 SCX AUS 12 페이지.

페이지 인쇄

Electrical connection

! Ovens equipped with a three-pole power supply

cable are designed to operate with alternating current

at the voltage and frequency indicated on the data

plate located on the appliance (see below).

Fitting the power supply cable

Connecting the electricity supply cable to the

mains

Install a standardised plug corresponding to the load

indicated on the data plate (see table).

The appliance must be directly connected to the mains

using an omnipolar switch with a minimum contact

opening of 3 mm installed between the appliance and

the mains. The switch must be suitable for the charge

indicated and must comply with current electrical

regulations (the earthing wire must not be interrupted

by the switch). The supply cable must be positioned

so that it does not come into contact with temperatures

higher than 50°C at any point.

! The installer must ensure that the correct electrical

connection has been performed and that it is fully

compliant with safety regulations.

Before connecting the appliance to the power supply,

make sure that:

• the appliance is earthed and the plug is compliant

with the law;

• the socket can withstand the maximum power of the

appliance, which is indicated on the data plate (see

below);

1. Open the terminal

board by inserting a

screwdriver into the side

tabs of the cover. Use

the screwdriver as a

lever by pushing it down

to open the cover (see

diagram).

2. Loosen the cable

clamp screw and remove

it, using a screwdriver as

a lever (see figure).

3. Remove the wire

contact screws L-N-

then fasten the wires

under the screw heads,

observing the colour

code: Blue (N), Brown (L)

and Yellow-Green (

• the voltage is in the range between the values

indicated on the data plate (see below);

• the socket is compatible with the plug of the

appliance. If the socket is incompatible with the

plug, ask an authorised technician to replace it. Do

not use extension cords or multiple sockets.

! Once the appliance has been installed, the power

supply cable and the electrical socket must be easily

accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced

by authorised technicians only (see Assistance).

! The manufacturer declines any liability should

these safety measures not be observed.

! If the supply cord is damaged, it must be replaced

by a special cord or assembly available from the

manufacturer or its service agent.

APPLIANCE SPECIFICATIONS

width 43.5 cm

Dimensions

height 32 cm

depth 41.5 cm

Volume

58 l

Voltage at 220-240 V~ 50/60 Hz or

Electrical

50 Hz (see data plate)

connections

maximum power absorbed 2800 W

Directive 2002/40/EEC on the

label of electric ovens.

Standard EN 50304

Energy consumption for Natural

ENERGY

convection – heating mode:

LABEL

Traditional mode

Declared energy consumption

Forced convection class -

heating mode:

Baking.

This appliance conforms to the

following EEC Directives:

2006/95/EEC dated 12/12/06

(Low Voltage) and subsequent

amendments - 2004/108/EEC

dated 15/12/04 (Electromagnetic

Compatibility) and subsequent

amendments - 93/68/EEC dated

22/07/93 and subsequent

amendments. 2002/96/EEC

and subsequent amendments.

AUS