Ariston FK 737 SCX AUS Gebruiksaanwijzing - Pagina 3
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Ariston FK 737 SCX AUS. Ariston FK 737 SCX AUS 12 pagina's.
Pagina afdrukken
Electrical connection
! Ovens equipped with a three-pole power supply
cable are designed to operate with alternating current
at the voltage and frequency indicated on the data
plate located on the appliance (see below).
Fitting the power supply cable
Connecting the electricity supply cable to the
mains
Install a standardised plug corresponding to the load
indicated on the data plate (see table).
The appliance must be directly connected to the mains
using an omnipolar switch with a minimum contact
opening of 3 mm installed between the appliance and
the mains. The switch must be suitable for the charge
indicated and must comply with current electrical
regulations (the earthing wire must not be interrupted
by the switch). The supply cable must be positioned
so that it does not come into contact with temperatures
higher than 50°C at any point.
! The installer must ensure that the correct electrical
connection has been performed and that it is fully
compliant with safety regulations.
Before connecting the appliance to the power supply,
make sure that:
• the appliance is earthed and the plug is compliant
with the law;
• the socket can withstand the maximum power of the
appliance, which is indicated on the data plate (see
below);
1. Open the terminal
board by inserting a
screwdriver into the side
tabs of the cover. Use
the screwdriver as a
lever by pushing it down
to open the cover (see
diagram).
2. Loosen the cable
clamp screw and remove
it, using a screwdriver as
a lever (see figure).
3. Remove the wire
contact screws L-N-
,
then fasten the wires
under the screw heads,
observing the colour
code: Blue (N), Brown (L)
and Yellow-Green (
).
• the voltage is in the range between the values
indicated on the data plate (see below);
• the socket is compatible with the plug of the
appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it. Do
not use extension cords or multiple sockets.
! Once the appliance has been installed, the power
supply cable and the electrical socket must be easily
accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced
by authorised technicians only (see Assistance).
! The manufacturer declines any liability should
these safety measures not be observed.
! If the supply cord is damaged, it must be replaced
by a special cord or assembly available from the
manufacturer or its service agent.
APPLIANCE SPECIFICATIONS
width 43.5 cm
Dimensions
height 32 cm
depth 41.5 cm
Volume
58 l
Voltage at 220-240 V~ 50/60 Hz or
Electrical
50 Hz (see data plate)
connections
maximum power absorbed 2800 W
Directive 2002/40/EEC on the
label of electric ovens.
Standard EN 50304
Energy consumption for Natural
ENERGY
convection – heating mode:
LABEL
Traditional mode
Declared energy consumption
Forced convection class -
heating mode:
Baking.
This appliance conforms to the
following EEC Directives:
2006/95/EEC dated 12/12/06
(Low Voltage) and subsequent
amendments - 2004/108/EEC
dated 15/12/04 (Electromagnetic
Compatibility) and subsequent
amendments - 93/68/EEC dated
22/07/93 and subsequent
amendments. 2002/96/EEC
and subsequent amendments.
AUS
3