Ariston FTGHG 751 D/A LPG 사용 설명서 - 페이지 5

{카테고리_이름} Ariston FTGHG 751 D/A LPG에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston FTGHG 751 D/A LPG 13 페이지.

페이지 인쇄

Installation

! Before operating your new appliance please read this instruction booklet

carefully. It contains important information for safe use, installation and care

of the appliance.

! Please keep these operating instructions for future reference. Pass them on

to possible new owners of the appliance.

! This appliance must be installed by an authorised person in accordance with

this instruction manual, AS/NZS 5601.1 – Gas installations (installation and

pipe sizing), local gas fitting regulations, local electrical regulations, Building

Code of Australia and any other government authority.

Positioning

! Keep packaging material out of the reach of children. It can become a choking

or suffocation hazard (see Precautions and tips).

! The appliance must be installed by a qualified professional according to the

instructions provided. Incorrect installation may cause harm to people and

animals or may damage property.

! This unit may be installed and used only in permanently ventilated rooms.

The following requirements must be observed:

• The room must be equipped with an air extraction system that expels

any combustion fumes. This may consist of a hood or an electric fan that

automatically starts each time the appliance is switched on.

In a chimney stack or branched flue.

(exclusively for cooking appliances)

• The room must also allow proper air circulation, as air is needed for

combustion to occur normally. The flow of air must not be less than 2 m

per kW of installed power.

The air circulation system may take air directly

from the outside by means of a pipe with an

inner cross section of at least 100 cm

opening must not be vulnerable to any type

of blockages.

Examples of

ventilation holes

for comburant air.

The system can also provide the air needed for

Adjacent

Room to be

combustion indirectly, i.e. from adjacent rooms

Room

Vented

fitted with air circulation tubes as described

above. However, these rooms must not be

communal rooms, bedrooms or rooms that

may present a fire hazard.

Enlarging the ventilation slot

between window and floor.

• Intensive and prolonged use of the appliance may necessitate

supplemental ventilation, e.g. opening a window or increasing the power

of the air intake system (if present).

• Liquid petroleum gas sinks to the floor as it is heavier than air. Therefore,

rooms containing LPG cylinders must also be equipped with vents to allow

gas to escape in the event of a leak. As a result LPG cylinders, whether

partially or completely full, must not be installed or stored in rooms or

storage areas that are below ground level (cellars, etc.). It is advisable to

keep only the cylinder being used in the room, positioned so that it is not

subject to heat produced by external sources (ovens, fireplaces, stoves,

etc. ) which could raise the temperature of the cylinder above 50°C.

Fitting the appliance

Gas inlet is located at the rear left hand side 25 mm in from the rear edge.

Side clearances—(Measurements B, & C) Where B, measured from the

periphery of the nearest burner to any vertical combustible surface, or vertical

combustible surface covered with toughened glass or sheet metal, is less

than 200 mm, the surface shall be protected to a height C of not less than

150 mm above the hob for the full dimension (width or depth) of the cooking

surface area. Where the gas cooking appliance is fitted with a "splashback",

protection of the rear wall is not required.

• The installation cavity should have the dimensions indicated in the figure.

Fastening hooks are provided, allowing you to fasten the hob to tops that

are between 20 and 40 mm thick. To ensure the hob is securely fastened

to the top, we recommend you use all the hooks provided.

Directly to

the Outside

• Before fastening the cooktop in place, position the seal (supplied) along

the perimeter of the countertop, as shown in the figure.

; the

This appliance must be installed with the following clearances:

Side clearance 55 mm

Overhead clearances-(Measurement A).

Range hoods and exhaust fans shall be

installed

in accordance with the manufacturer's relevant

instructions. However, in no case shall the

clearance between the highest part of the

hob of the gas cooking appliance and a range

hood be less than 600 mm or, for an overhead

exhaust fan, 750 mm.

555 mm

55 mm clearance from bench top (sides)

Front and rear clearance 5 mm

5 mm clearance from bench top (front & rear)