Ariston FTGHG 751 D/A LPG Руководство по эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Варочная панель Ariston FTGHG 751 D/A LPG. Ariston FTGHG 751 D/A LPG 13 страниц.
Печатать страницу
Installation
! Before operating your new appliance please read this instruction booklet
carefully. It contains important information for safe use, installation and care
of the appliance.
! Please keep these operating instructions for future reference. Pass them on
to possible new owners of the appliance.
! This appliance must be installed by an authorised person in accordance with
this instruction manual, AS/NZS 5601.1 – Gas installations (installation and
pipe sizing), local gas fitting regulations, local electrical regulations, Building
Code of Australia and any other government authority.
Positioning
! Keep packaging material out of the reach of children. It can become a choking
or suffocation hazard (see Precautions and tips).
! The appliance must be installed by a qualified professional according to the
instructions provided. Incorrect installation may cause harm to people and
animals or may damage property.
! This unit may be installed and used only in permanently ventilated rooms.
The following requirements must be observed:
• The room must be equipped with an air extraction system that expels
any combustion fumes. This may consist of a hood or an electric fan that
automatically starts each time the appliance is switched on.
In a chimney stack or branched flue.
(exclusively for cooking appliances)
• The room must also allow proper air circulation, as air is needed for
combustion to occur normally. The flow of air must not be less than 2 m
per kW of installed power.
The air circulation system may take air directly
from the outside by means of a pipe with an
inner cross section of at least 100 cm
opening must not be vulnerable to any type
of blockages.
A
Examples of
ventilation holes
for comburant air.
The system can also provide the air needed for
Adjacent
Room to be
combustion indirectly, i.e. from adjacent rooms
Room
Vented
fitted with air circulation tubes as described
above. However, these rooms must not be
communal rooms, bedrooms or rooms that
may present a fire hazard.
Enlarging the ventilation slot
between window and floor.
• Intensive and prolonged use of the appliance may necessitate
supplemental ventilation, e.g. opening a window or increasing the power
of the air intake system (if present).
• Liquid petroleum gas sinks to the floor as it is heavier than air. Therefore,
rooms containing LPG cylinders must also be equipped with vents to allow
gas to escape in the event of a leak. As a result LPG cylinders, whether
partially or completely full, must not be installed or stored in rooms or
storage areas that are below ground level (cellars, etc.). It is advisable to
keep only the cylinder being used in the room, positioned so that it is not
subject to heat produced by external sources (ovens, fireplaces, stoves,
etc. ) which could raise the temperature of the cylinder above 50°C.
Fitting the appliance
Gas inlet is located at the rear left hand side 25 mm in from the rear edge.
Side clearances—(Measurements B, & C) Where B, measured from the
periphery of the nearest burner to any vertical combustible surface, or vertical
combustible surface covered with toughened glass or sheet metal, is less
than 200 mm, the surface shall be protected to a height C of not less than
150 mm above the hob for the full dimension (width or depth) of the cooking
surface area. Where the gas cooking appliance is fitted with a "splashback",
protection of the rear wall is not required.
• The installation cavity should have the dimensions indicated in the figure.
Fastening hooks are provided, allowing you to fasten the hob to tops that
are between 20 and 40 mm thick. To ensure the hob is securely fastened
to the top, we recommend you use all the hooks provided.
Directly to
the Outside
/h
3
• Before fastening the cooktop in place, position the seal (supplied) along
the perimeter of the countertop, as shown in the figure.
; the
2
This appliance must be installed with the following clearances:
Side clearance 55 mm
Overhead clearances-(Measurement A).
Range hoods and exhaust fans shall be
installed
in accordance with the manufacturer's relevant
instructions. However, in no case shall the
clearance between the highest part of the
hob of the gas cooking appliance and a range
hood be less than 600 mm or, for an overhead
exhaust fan, 750 mm.
555 mm
55 mm clearance from bench top (sides)
Front and rear clearance 5 mm
GB
5 mm clearance from bench top (front & rear)
5