Whirlpool 6ALBR5233JQ0 서비스 매뉴얼 - 페이지 5

{카테고리_이름} Whirlpool 6ALBR5233JQ0에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 6ALBR5233JQ0 23 페이지. Top load washing machine

WHIRLPOOL CONSUMER SERVICES

SERVICING THE ATC COMPONENTS

1. To remove the ATC Control Board (See Figure 2 on Page 4), grip the sides of the board and

pull it straight out of its connector.

2. To remove the thermistor (See Figure 5) :

I. Disconnect the two wire connectors from the thermistor terminals.

II. Remove the two clamps from the hoses and pull the hoses off the connectors.

III. Pry the pins at the top at the top and bottom of the thermistor out of their console

holes and twist the body 90° in either direction. Pull the tab out of the console slot

and remove the thermistor.

The following steps test the ATC portion of the system.

Notes :

A properly operating ATC system will provide the following water temperatures in

the washer after the machine has filled with water ready for the wash operation :

Cold Wash : 24° ° ° ° C ± ± ± ± 3° ° ° ° C

2. The hot wash and all rinse water fills are not controlled by the ATC.

3. On cold wash setting Using gravity feed hot water systems may not allow the wash

water to achieve 24° ° ° ° C ± ± ± ± 3° ° ° ° C.

Warm Wash : 38° ° ° ° C ± ± ± ± 5° ° ° ° C

Model 6ALBR5233JQ0

Page 5 of 23