Whirlpool 6ALBR5233JQ0 서비스 매뉴얼 - 페이지 6

{카테고리_이름} Whirlpool 6ALBR5233JQ0에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 6ALBR5233JQ0 23 페이지. Top load washing machine

WHIRLPOOL CONSUMER SERVICES

TEST PROCEDURE

1. Set the water temperature selector switch to Warm wash / Cold rinse.

2. Set the timer to the start of a wash cycle, start the machine and the tub will begin filling with

water.

3. Both the hot and cold inlet valves will operate continuously for approximately 55 seconds.

After the 55 seconds the hot water inlet valve should remain energised while the cold water

inlet valve will cycle on and off.

4. If the cold water inlet valve is not working properly :

• Disconnect the machine from the electrical supply.

• Check the ATC Control Board for proper installation in its connector.

• Make sure that the harness wires are in their proper location in the connector.

• Remove the ATC Control Board from its connector.

• Using an ohmmeter, measure the resistance of the thermistor at connector harness

wires 3 (OR-W) and 9 (BR). Compare the reading with the values in the "Thermistor

Resistance Chart" (See Page 8).

If the ohmmeter readings are incorrect Remove and replace the thermistor and repeat

the test.

Notes :

I. If the hot water temperature is less than 49° ° ° ° C, the cold water inlet valve

may turn off and stay off.

II. If the cold water temperature is above 21° ° ° ° C, the cold water inlet valve will

stay on continuously.

III. If the thermistor is open-circuit, the cold water inlet valve will stay off. If

the thermistor is shorted, the cold water inlet valve will stay on

continuously.

5. Set the water temperature selector switch to Cold wash / Cold rinse.

6. Set the timer to the start of a wash cycle, start the machine and the tub will begin filling with

water.

7. The cold water inlet valve should remain energised while the hot water inlet valve will cycle

on and off. If the cold water temperature is above 18° ° ° ° C, the hot water inlet valve may

not operate.

If the hot water inlet valve is not working properly disconnect the machine from the electrical

supply, replace the ATC Control Board and repeat steps 6. & 7.

Model 6ALBR5233JQ0

Page 6 of 23