Whirlpool 8559 사용 설명서 지침 - 페이지 11

{카테고리_이름} Whirlpool 8559에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 8559 13 페이지. 8kg, 1200rpm, washing machine with microban anti-bacterial protection 8003437443664 awoe 8559

페이지 인쇄

30106320GB.fm Page 11 Tuesday, December 1, 2009 10:47 AM

Red

Indication

indication

on display

lights up

from "F03" to "F35"

(except "F18" and

from "F40" to "F43"

"F02" or "FA"

"Service"

"F18" or "FoD"

Black process 45.0° 130.0 LPI

"Electrical module fault"

Push the "Reset" button for at least 3 seconds.

"F24")

"Electrical module fault"

Make sure that the water tap is open. If yes:

• Switch the washing machine off by turning the programme

selector to the "Off/O" position; then turn the programme

selector to a wash programme again. If there is still a failure:

• Push the "Reset" button for at least 3 seconds.

"F24"

"Water level too high" (after programme cancellation or false

operating). Switch off the washing machine by turning the

programme selector to the "Off/O" position. Turn the

programme selector to a wash programme again, shortly press

the "Reset/Drain" button and press "Start (Pause)" within 15

seconds to start the Drain programme.

"Waterstop fault"

For models with big display, the red "Waterstop" symbol

will also light up in this case.

Turn the programme selector to the "Off/O" position, pull out

the mains plug and turn the water tap off. Tilt the appliance

forward carefully to allow collected water to flow out from the

bottom. Then:

• Plug in the appliance again.

• Turn the water tap on (if water immediately flows into the

appliance without the appliance being started, there is a failure;

turn off the tap and notify the After-Sales Service).

• Select and start the desired programme again.

"Overfoaming"

Too much foam interrupted the wash programme.

• Select and start the "Rinse & Spin" programme.

• Afterwards select and start the desired programme again,

using less detergent. See also paragraph "The machine is at a

standstill...." on first page of Troubleshooting Guide.

If any of the faults described above persist, unplug the

appliance, turn off the water tap and contact our

After-Sales Service (see next chapter).

GB 11

Description

Causes

Solutions